Simple Operating Functions; Resetting To Factory Status - HomeMatic HM-PB-2-WM Montageanleitung

8

Simple operating functions

After teaching, simple operating functions are
available.
HM-PB-2-W:
The 2 buttons (on a common rocker) are taught on
the receiver as a button pair (ON/OFF) in factory
status. Switch actuators and dimmers can then be
switched ON/OFF or dimming occurs by holding
the button pressed. The blind actuators move up or
down.
HM-PB-4-W:
The 2 buttons (on a common rocker) are taught as a
button pair (ON/OFF) for the receiver upon delivery,
depending on from which pair the button was
pressed for teaching. Switch actuators and dimmers
can then be switched ON/OFF or dimming occurs
by holding the button pressed. The blind actuators
move up or down.
38
9

Resetting to factory status

Hold the teach button down for at least 5 seconds.
The device LED starts to flash slowly in red. (If you
want to abort the reset procedure at this time, you
can press the teach button briefly again or wait 15
seconds. In either case, the flashing red will stop.)
To reset the device, press the teach button again
for at least 5 seconds. The LED starts to flash in red
faster while the button is held down. Releasing the
button completes the reset procedure and the LED
is illuminated for approx. 3 seconds to confirm the
reset operation.
Possible error messages:
(This error can occur now if you have a center
and have taught the device for this center.)
If the LED does not start flashing after holding the
button down for 5 seconds but is illuminated con-
tinuously, the device cannot be reset! In this case,
the encoding is active using a system security key
that differs from the key delivered with the system.
In order to reset the device, you must use the
configuration software of the center for resetting!
The procedure is described in the center software
instructions.
39