Resetting Tofactory Status - HomeMatic HM-RC-Key3-B Bedienungsanleitung

8 Resetting to factory status
Hold the teach button down for longer than 5
seconds. The remote control LED starts to flash
slowly.
(If you want to abort the reset procedure at this
time, you can press the teach button briefly again
or wait 15 seconds. In either case, the flashing red
will stop.)
To reset the remote control, press the teach button
again for at least 5 seconds. The LED starts to flash
in red faster while the button is held down.
Releasing the button completes the reset procedure
and the LED is illuminated for approx. 3 seconds to
confirm the reset operation.
Possible error messages:
(This error can only occur if you have a center
and have taught the remote control for this center.)
If the LED does not start flashing after holding
the button down for 5 seconds but is illuminated
continuously, the remote control cannot be reset!
In this case, the encoding is active using a system
security key that differs from the key delivered with
39