Memorising 3-Button Remote Controls (Telis Io, Telis Composio Io, Etc.) - SOMFY ROLLIXO io Installationsanleitung

Rollixo io
> Memorising via the programming interface
If the installation already includes other io-homecontrol® products with at least
memorise the system key (see above).
[1]. Press button on the receiver until the indicator light comes on
Prog
permanently.
[2].
rapidly.
This may take from a few seconds up to around 1 minute, depending on
the number of products present in the system.
[3].
time delay of 10 seconds.
[1]
Prog
Prog
[2]
> Memorising by copying a previously memorised Keytis io
remote control
• Complete copying of a Keytis io remote control
This operation is used to copy all the buttons on a previously memorised
remote control.
The new remote control must not be memorised for another automatic control
system.
Ensure that the new remote control has memorised the system key.
[1]. Press the "PROG" button on the memorised remote control until the green
indicator light comes on (2 s).
[2]. PROG" button on the new remote control.
rapidly (a few seconds).
[1]
[2]
Copyright © 2014 Somfy SAS. All rights reserved.
[3]
Remote control memorised
Remote
control to be
memorised
• Copying individual buttons on the Keytis io remote control
This operation is used to copy the memorisation of a single button on a
previously memorised remote control to a blank button on a new remote control.
Ensure that the new remote control has memorised the system key.
[1]. Press the "PROG" button on the memorised remote control until the green
indicator light comes on (2 s).
[2].
control.
[3]. PROG" button on the new remote control.
[4].
control.
[1]
Remote control memorised
[3]
Remote control to be memorised
It is not possible to memorise Keytis io remote controls in the
following cases:
- The remote control has not memorised the system key.
- Several of the installation's receivers are in programming mode.
- Several remote controls are in key transfer or memorisation mode.
Incorrect memorisation is indicated by a rapid series of beeps
remote control.
9.4 Memorising 3-button remote controls (Telis io,
Telis Composio io, etc.)
> Button functions on a 3-button remote control
Complete opening
> Memorising via the programming interface
To memorise a 3-button io two-way remote control (Telis io, Impresario Chronis
io, etc.), ensure that the remote control has memorised the system key (see
page 12).
[1]. Press button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press the PROG button on the back of the remote control to be memorised
within a maximum of 10 minutes.
The indicator light above button
control is memorised in the receiver.
[1]
Prog
Prog
[2]
[4]
my
Stop Complete closing
Prog
[2]
Prog
13