Programming The Xse Transmitter; Recognising Magnets; Checking The Operation Of The Receiver; Operation In Sequential Mode - SOMFY ROLLIXO io Installationsanleitung

Rollixo io
[1]. Press button to position the garage door in the low position.
1 2 3 4
STOP Prog
[2]. Attach the magnet to the edge of the runner, positioning it in line with the
transmitter.
This operation is important. Ensure the dimensions are observed.

4.3 Programming the XSE transmitter

[1]. Press the button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2
on the receiver goes out and the receiver Prog
the transmitter and receiver communicate with each other).
The transmitter is memorised in the receiver.
1 2 3 4
STOP Prog
4 s
1 2 3 4
STOP Prog

4.4 Recognising magnets

It is essential that the following procedure is observed to ensure
completely safe operation of the door.
The door must be in the intermediate position before the magnet
recognition procedure can be started.
Do not press the safety edge during the magnet recognition
procedure.
Copyright © 2014 Somfy SAS. All rights reserved.
10 mm maxi.
Lower
magnet
1 2 3 4
STOP Prog
1 2 3 4
STOP Prog
Run a complete cycle (opening then closing) using buttons
1 2 3 4
STOP Prog
1 2 3 4
Prog
STOP
At the end of installation, it must be checked that the limitation of forces
complies with appendix A of the standard EN 12 453.
5 - CHECKING OPERATION OF THE
RECEIVER

5.1 Operation in sequential mode

STOP

5.2 Integrated lighting

The lamp comes on each time a command is sent to the receiver.
It goes out 2 minutes after the door stops.

5.3 Orange light

5.4 Cells

If the cells are blocked when the door is closed, it stops, then re-opens fully.
If the cells are blocked when the door is opened, the door continues its
movement.

5.5 Safety edge

If the safety edge is activated when the door is closing, it stops then re-opens
partially.
If the safety edge is activated while the door is opening, it continues its
movement.

5.6 Alarm (optional)

The alarm is triggered for 2 minutes if the door is fully closed and raised
manually. No movement of the door is possible when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in the
receiver to stop it.
The alarm can only be stopped with a memorised remote control.
and .
WARNING
STOP
STOP
7