Advanced Parameter Setting; Different Operating Modes - SOMFY ROLLIXO io Installationsanleitung

Rollixo io
If a wired safety edge replaces a radio safety edge, the radio safety
edge transmitter must be cleared (see section 12) to ensure the
wired safety edge is taken into account.
> Orange LED (part no. 9017842)
ge
9
4 W max.
> Key lock
Successive presses cause the motor to move (initial position: door closed) as
per the following cycle: open, stop, close, stop, open, etc.
Safety Edge
Sec
7
> Alarm
It is essential to have programmed at least one remote control. The
alarm can only be stopped with a memorised remote control.
• Installing and connecting the alarm
Mount the alarm to the receiver with the bolt provided.
Connect the alarm connector.
• Activating/Deactivating the alarm
To activate/deactivate the alarm, simultaneously press the
The alarm emits a beep if it has been activated.
1 2 3 4
STOP Prog
10
KeySwitch 24V dc 24V C
Flash
10 11 12 13 14 15 16 17
KeySwitch Flash 24V
8 9 10 11 12 13 14 1
and
STOP
1 2 3 4
STOP Prog
• Alarm operation
The alarm is triggered for 2 minutes if the door is raised manually.
No movement of the door is possible when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in the
receiver to stop it. The alarm can only be stopped with a memorised remote
control.
• Alarm operation test
STOP
1
STOP
• Anti-intrusion function test
[1]. Press button to position the garage door in the low position.
[2]. Wait until the transmitter switches to sleep mode (instant if base magnet
installed).
[3]. Manually raise the door by pressing on the rubber.
The alarm is triggered.
[4]. Press a button on a remote control memorised in the receiver to stop the
alarm.
• Optional: lower magnet
4.2).

8 - ADVANCED PARAMETER SETTING

8.1 Different operating modes

> 2 operating modes are available:
Sequential (default mode)
Semi-automatic
buttons
and on the receiver simultaneously.
2 3 4
Prog
Each press on the remote control causes the
motor to move (initial position: door closed)
as per the following cycle: open, stop, close,
stop, open, etc.
In semi-automatic mode:
- pressing a button on the remote control
during opening has no effect,
- pressing a button on the remote control
during closing causes it to reopen.
Copyright © 2014 Somfy SAS. All rights reserved.