Memorising An Xse Safety Edge Transmitter; Clearing The Remote Controls; Clearing Individual Buttons On The Keytis Io Or Keygo Io Remote Controls; Clearing All Remote Controls - SOMFY ROLLIXO io Installationsanleitung

Rollixo io
> Memorising by copying a previously memorised 3-button io
remote control
To memorise a 3-button io two-way remote control (Telis io, Impresario Chronis
io, etc.), ensure that the remote control has memorised the system key (see
page 12).
2 s
Remote control memorised
10 - MEMORISING AN XSE SAFETY EDGE
TRANSMITTER
Memorising a new radio safety edge transmitter overwrites the previous
transmitter.
[1]. Press button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2 on the receiver goes out and the receiver Prog
while the transmitter and receiver communicate with each other).
The transmitter is memorised in the receiver.
[1]
1 2 3 4
STOP Prog
[2]
4 s
1 2 3 4
STOP Prog

11 - CLEARING THE REMOTE CONTROLS

11.1 Clearing individual buttons on the Keytis io or
Keygo io remote controls
This can be done:
- by memorising via the programming interface.
Memorising a button which has already been memorised will clear this button's
function.
- by clearing directly on the remote control (only on Keytis io remote controls).
Press the "PROG" button and the BUTTON to be cleared on the remote
control together.
14
Remote control to be memorised
1 2 3 4
STOP Prog
1 2 3 4
STOP Prog

11.2 Clearing all remote controls

[1]. Press button on the receiver (for approximately 7 seconds) until the
Prog
indicator light above it goes out.
[2]. Release button on the receiver when the indicator light goes out; the
Prog
All memorised remote controls will be cleared.
Prog
Prog
Press and hold down for 7 seconds
12 - DELETING A SAFETY EDGE
TRANSMITTER
Note: This operation must be carried out when a radio safety edge is replaced
with a wired safety edge.
[1]. Press button on the receiver (for approximately 14 s) until the indicator
Prog
light above it goes out.
[2]. Release button
Prog
The safety edge transmitter is cleared.
Prog Prog Prog
Press and hold down for 14 seconds
13 - LOCKING/UNLOCKING THE
PROGRAMMING BUTTONS
The programming buttons must be locked to ensure user safety. Failure to follow
this instruction may result in serious injury, e.g. due to crushing by the gate.
When the programming buttons are locked, the following functions cannot be
accessed:
- entering programming mode by pressing button
- entering motor end limit setting mode by pressing buttons
receiver
- setting the operating modes.
To lock the programming buttons, press buttons
STOP
STOP
To lock the programming buttons, repeat the locking procedure described
above.
Prog Prog Prog
Prog Prog Prog
WARNING
on the receiver
Prog
and
and on the receiver
Prog
STOP
1 2 3 4
Prog
1 2 3 4
Prog
Copyright © 2014 Somfy SAS. All rights reserved.
on the