Using The Unit - Stihl hse 81 Gebrauchsanleitung

English
After Finishing Work
Always clean dust and dirt off the
machine – do not use any grease
solvents for this purpose.
Spray the blades with STIHL resin
solvent. Run the motor briefly so that the
solvent is evenly distributed.
Maintenance and Repairs
Always switch off the machine and
disconnect the plug from the power
supply before carrying out any
maintenance work to reduce the risk of
injury from the motor starting
unintentionally.
Service the machine regularly. Do not
attempt any maintenance or repair work
not described in the instruction manual.
Have all other work performed by a
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and are supplied with
the necessary technical information.
Only use high-quality replacement parts
in order to avoid the risk of accidents
and damage to the machine. If you have
any questions in this respect, consult a
servicing dealer.
STIHL recommends the use of genuine
STIHL replacement parts. They are
specifically designed to match your
machine model and meet your
performance requirements.
28
Never attempt to modify your power tool
in any way since this will increase the
risk of personal injury.
Regularly check that the insulation of the
power cord and plug is in good condition
and shows no sign of ageing
(brittleness).
Electrical components, e.g. power cord,
may only be repaired or replaced by a
qualified electrician.
Clean plastic components with a cloth.
Do not use aggressive detergents. They
may damage the plastic.
Do not spray the machine with water.
Check tightness of mounting screws on
safety devices and the cutting
attachment and retighten if necessary.
Clean cooling air inlets in motor housing
as necessary.
Store the machine is a safe and dry
place.

Using the Unit

Cutting Season
Observe country-specific or municipal
rules and regulations for cutting hedges.
Do not use your power tool during other
people's rest periods.
Preparations
Use lopping shears or a chain saw to cut
out thick branches first.
Cutting Sequence
Cut the sides of the hedge first, then the
top.
If a radical cut is necessary, cut a little at
a time in several stages.
Rotating Handle
Your hedge trimmer is equipped with a
rotating handle to enhance user comfort
– see chapter on "Rotating Handle".
Disposal
Do not throw cuttings into the garbage
can – they can be composted!
HSE 61, HSE 71, HSE 81