Safety Systems; Cleaning - Zummo Z14 Bedienungsanleitung

8

SAFETY SYSTEMS

The machine has various safety systems:
1 If the Front Cover is not assembled or is improperly assembled, the display will
show message Error with the Front Cover and Hopper symbols flashing.
2 If the Juicetray is not assembled or improperly assembled, the machine will not
operate and the display will show Error message. The tray flashes as a shadow.
3 If for any reason the machine gets blocked during operation, after a few seconds
the motor will stop automatically and the display will show Error message with a
faulty flashing icon, until the cause of the blockage is removed.
4 Thanks to a thermal protection system in the motor, in the event of overheating the
machine will stop and the display will show Error message and a thermometer icon.
In this case, please wait around 10 minutes to allow the motor temperature to
decrease. The error message will disappear. Please check that the ventilation
gratings are not obstructed.
5 If there is no message on the display, it means there is no power supply. Check that
the power switch is on and that the plug fuse is not burnt out (Fig.16).
9
MACHINE CLEANING
The machine squeezing area and parts must be cleaned daily.
ƒ
If the machine is in operation, stop it always using the Programmer StoP bottom. Never
attempt to stop the machine using the main switch. Failure to follow this recommendation
will cause the machine to stop in a position that impedes cleaning; possibly leading to
breakage of parts due to poor handling.
ƒ
Disconnect the machine using the power switch. (Fig. 3)
ƒ
Remove the Front Cover and wash it using a damp cloth. ATTENTION!: NEVER use
products that may scratch it).
ƒ
Remove the Filter tray to get access to the Juicetray Fastening nuts.
ƒ
Juicetray and Blade are removed by unscrewing the fastening nuts and pulling outwards
horizontally.
ƒ
Unscrew the Balls inside the Juicetray (Fig. 5). There is one washer underneath each Ball.
Be careful not to lose them! You may use a dishwasher to wash Juicetray, Filter, Filter
Tray and Blade. TAKE EXTRA CARE WITH THE BLADE (Fig. 12) since it is very sharp and
may cause injuries.
ƒ
Remove the Cups unscrewing the Fastening Nuts, and wash them.
ƒ
Remove and wash both Plastic Bins and the Bins Base and wash them.
ƒ
Once all plastic parts have been removed, clean the machine steel front.
16