Electrical Diagram - Zummo Z14 Bedienungsanleitung

The display shows message
Error and a flashing Icon.
Blade breaks
Not enough juice is being
extracted from the fruit
Hooper is not delivering fruits
so the squeezing area
Hooper is delivering several
oranges at the same time into
the squeezing area
For any advice or to request spare parts, you should state the model and serial number of your machine (Fig.
2).
14

ELECTRICAL DIAGRAM

1 Fuse
2 Power switch
3 Circuit board
4 Counter micro-switch
5 Casing micro-switch
4
9
2
1
Check if the fruit is frozen.
Check for piled-up fruit peels inside the Juicetray.
Check if Balls are correctly tightened
Check to see if the orange peels are stuck to the inside of the Cups.
Check if components of different squeezing sets are mixed
To unblock the machine, use the 5mm Allen key located at the right of the lower
vent. Insert it into the hole on the right side and, with the machine switched off, turn
clockwise until the cups are raised, removing the obstruction. WARNING: Make
sure the Allen key is removed before switching the machine on.
The Peel Extracting Bands are loose or broken and peels are piling up in the
Juicertray.
Cup nuts are too loose.
Balls are loose.
The low-pass filter is missing.
Fruit peel is too thin. Place one extra washer under each ball.
Fruit is too big for the Fruit Classifiler in use.
Fruit is too small for the Fruit Classifier in use.
Hopper not properly assembled. See section nº 9 of this manual.
5
3
6 Lid micro-witch
7 Motor
8 Condenser
9 Tray micro-switch
6
7
8
19