Safety Systems - Zummo Z06 Bedienungsanleitung

6.6. SAFETY SYSTEMS

The machine is equipped with several safety systems:
1 If the cover is not properly in place, with its clasps fully fitted inside the slots (Figs. 8 & 9),
the display will show the StoP message and the buttons will not respond.
2 If the tray holding the squeezer and the blade are not properly in place, and the nuts not
tightened, the machine will not run and StoP will appear on the display (Fig. 10)
3 If for some reason the machine were to become blocked while running, the motor will
automatically be stopped after a few seconds, and a blinking A will appear on the display,
waiting for the cause of the blockage to be removed.
4 The machine is equipped with a system of thermal protection in the motor. In the event of
overheating, the machine will stop and the display will show the StoP message. In such a
case, wait roughly five minutes for the temperature to go down, at which point StoP will be
replaced on the display by the last selection. Check to make sure the ventilation grating is
unobstructed.
5 If no message appears on the display, this will be due to the lack of voltage. Check that the
power switch is turned on and that the safety fuse to the power jack has not burnt out.
Observe that there are two fuses (Fig.11): the first fuse is the one that may be burnt out
while the second one is the spare fuse.
22