Installation; Start Up - Zummo Z14 Bedienungsanleitung

3

INSTALLATION

x
Attention! The machine weighs 55 Kg. When moving machine, we suggest that this be
accomplished by two persons. The best way to lift the machine is to use one hand to get a
grip underneath the machine rear and the other hand placed beneath the Squeezing Tray.
(Fig. 6)
x
Place the machine on a sufficiently sturdy and stable base.
x
Make sure that the machine's voltage and frequency match the values of your electrical
installation. See the identification plate. (Fig. 2)
x
Use an electrical outlet equipped with an effective earth connection (0.03A). This outlet
should be used exclusively by the juice extraction machine. Do not plug other appliances
into the outlet.
x
Before operating the machine, wash all machine parts that will be in contact with juice;
Balls, Blade, Juicetray, Fliter Tray, Filter and Front Cover.
x
Turn ON the power switch (Fig. 3 ( I=On, O=Off )). If no message appears on the display
(Fig. 4), there is lack of power supply. Make sure you have connected the plug to a
powered circuit and that the power switch is switched on. Once this is done, the
Programmer display will show one of the following messages:
a. If the display shows a number (Disp. 2), the machine is ready to start operating.
b. If the display shows the Error message (Disp. 5), then the Front Cover is not correctly
assembled and should be re-assembled correctly.
c. If the display shows the Error message (Disp. 6), the Juice Tray is not correctly
assembled and should be re-assembled correctly.
d. If the display shows the Error MEM (Disp. 9), it means the Programmer is faulty.
Contact your local supplier for technical assistance.
4

START UP

x
Select the correct set of Cups, Balls and Fruit Selector according to the size of the fruit to
be squeezed. See Machine Accessories section in this manual.
x
Fit the rubber rings to the Blade, according to the set of Cups and Balls previously selected
according to figs. 20 -21 – 22.
x
Once the machine is switched on, the display will show either a number between 1 and 50
or the letter C. The number indicates the quantity of fruits to be squeezed, while the letter C
sets the machine to squeeze continuously for approximately 30 minutes.
x
To st the number of oranges to squeeze, press the SELECT button repeatedly to increase
the number (from 1 to 50, followed by the letter C; 1,2,3,..........48,49,50,C,1,2,3.....).
Alternatively, press and hold the SELECT button for 2 seconds and the number will
decrease. Continue until you visualize the wanted number.
x
The selected number will be stored on the display after the first complete squeeze cycle is
finished. The number will be stored even if the machine is switched off. You may change
the number repeating the complete number selection process.
x
Press the ON button to start squeezing. Druing the process, the display will show the
remaining amount of fruits to be squeezed. If you wish to repeat the process, simply press
ON. To stop the process, press the STOP button.
14
(Disp. 2)
(Disp. 6)
(Disp. 5)
MEM
(Disp. 9)