Stopping; Counter Function; Selector Locking Function - Zummo Z14 Bedienungsanleitung

x
ATTENTION!!!: Do NOT place your hand into the basket while the machine is operating
(Fig.23).
5

STOPPING

To stop the machine when is operation, press the Stop button. The display will show a timer
and the message Stop. The machine will stop once the Cups have reached the vertical
position. Once the machine completely stops, the display will show again the number of fruits to
squeeze.
6

COUNTER FUNCTION

The display stores the total number of cycles* completed. To visualize the figure,
ƒ
Being the machine stopped and in stand-by, press the STOP button
ƒ
The figure will appear on the display for a few seconds.
Bear in mind that all machines show a minimum of 400 to 500 cycles completed for quality
control testing.
*(cycle = complete set of movements to squeeze a piece of fruit)
7

SELECTOR LOCKING FUNCTION

In order to lock the SELECT button to avoid unwanted changes of the number of fruits to
squeeze, carry out the following operations:
ƒ
Select the number on the display you wish to lock.
ƒ
Press the button ON and wait until the machine stops.
ƒ
Switch off the machine using the power switch.
ƒ
Being the machine switched off, press and hold STOP.
ƒ
Switch on the power keeping STOP button pressed for four seconds.
ƒ
The display will show a four digits number.
ƒ
Press the button SELECT (this button controls the two right digits) and press the button
ON (this button controls the two left digits) at the same time to select the number 7437.
ƒ
Press STOP and the display will show - - - -
ƒ
Turn off the machine using the power switch. If you fail to do this, the display will keep
showing the message - - - -
ƒ
Switch on the machine. Now the SELECT button is locked and the display will show Lock.
To unlock the SELECT button, repeat exactly the same operation.
COUNTER
15