Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
Place the handles on their places and tighten each
with two screws. Attach the end plugs to the axel
ends with two screws. Then press the plastic cover
plugs over the screws.
CONSOLE
The console needs the batteries for keeping the
user information in memory. Detach the lid of the
battery casing at the back of the meter and place
batteries (2 x 1.5 V AA) in the retainer.
Note the + and - signs! Push the battery casing lid
back into place.
Connect the cables from the front tube and
console. Push the connected cables inside the front
tube and place the console on top of the front
tube.
Beware not to damage the cables!
NOTE!
Attach the console with four screws. Remove the
protective films from the console display.
FOOT BOARDS
Attach the footboards to the desired place on the
pedal cranks with four screws and locking nuts.
DRINK BOTTLE
Secure the drink bottle rack with a screw.
TRANSFORMER
Before connecting the equipment to a power
source, make sure that local voltage matches that
indicated on the type plate: the equipment operates
at either 230 V or 115 V (North American
version). Plug the socket end of the transformer
cord into the connector, just above the rear support
in the center of the frame, and the other end into
the wall socket.
The equipment must be connected to a
NOTE!
grounded wall socket. Do not use extension wires
when connecting the equipment to the power
IMPORTANT!
source. Make sure the power cord does not run
underneath the equipment.
Always switch off the power and
DANGER:
unplug this appliance from the electrical outlet
immediately after using.
To reduce the risk of burns, fire, electric
WARNING:
shock, or injury to persons:
An appliance should never be left unattended
1)
when plugged in. Unplug from outlet when not in
use, and before carrying out any maintenance or
repair procedures.
Do not operate under blanket or other
2)
combustive material. Excessive heating can occur
and cause fire, electric shock, or injury to persons.

EXERCISING

If the product is not stable, adjust the stabilizing
screws under the rear support appropriately.
O W N E R ' S M A N U A L
G B
B A T AV U S
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis