Cocraft PRO RT18-PL Bedienungsanleitung Seite 5

f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits, etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
5) Battery tool use and care
a) Recharge only with the charger specified by the manufacturer. A charger that
is suitable for one type of battery pack may create a risk of fire when used with
another battery pack.
b) Use power tools only with specifically designated battery packs. Use of any
other battery packs may create a risk of injury and fire.
c) When battery pack is not in use, keep it away from other metal objects, like
paper clips, coins, keys, nails, screws or other small metal objects, that can
make a connection from one terminal to another. Shorting the battery terminals
together may cause burns or a fire.
d) Under abusive conditions, liquid may be ejected from the battery; avoid contact.
If contact accidentally occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from the battery may cause
irritation or burns.
6) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Specific safety instructions for reciprocating saws
Important: Always remove the battery from the reciprocating saw before performing
any adjustment, service or maintenance.
a) Keep hands and fingers away from the saw blade and other moving parts. Do not
reach under the workpiece being sawn. The blade or your hand could be out of
your field of vision.
b) Ensure that there are no hidden electrical wires or water pipes in the ceiling or wall
into which you about to saw. Remove all fuses and cut off the power supply to any
wiring circuits which may be connected to any electrical wiring concealed within
the wall. Grip only the plastic parts of the reciprocating saw. Never grip any metal
parts of the saw when cutting in areas where there might be live electrical wires.
c) Do not use blunt or damaged saw blades. Bent saw blades can easily break or
cause kickback.
d) Start the saw and allow it to attain proper operating speed before sawing.
e) Clamp down any small workpieces before sawing them.
f) Make sure that the settings are correct and that the blade is securely fastened in
the blade holder before beginning to saw.
5