Switching On And Off - Cocraft PRO RT18-PL Bedienungsanleitung

Charging
Charging temperature range: 5–40 °C.
1. Connect the charger to a wall socket.
The green LED will come on.
2. Slide the battery into the charger. The green
LED will go out and the red LED will come
on whilst the battery is being charged.
3. When the battery has been fully charged,
the green LED will come on.
4. Remove the battery from the charger and
disconnect the charger from the mains
once the battery is fully charged.
• The charging time is approximately 40 min.
• The battery may become hot whilst it is being charged. This is completely normal.
• The battery and charger function best at normal room temperature. Do not charge
the battery in direct sunlight or in temperatures below 5 °C. The temperature range
for charging is 5–40 °C.
• When the battery becomes discharged, the electronics of the battery will turn
the reciprocating saw off automatically.
• For long-term storage (months) the battery should first be fully charged.
Charging error indications
• The red LED flashes: Defective battery, change the battery.
• The green LED flashes: Battery too hot or too cold to charge. Let the battery reach
normal room temperature before charging.
Attaching/detaching the battery
1. Slide the power trigger lock (6) to the left to lock the
power trigger (7). This is to prevent the reciprocating
saw from starting accidentally when the battery is
being installed.
2. Slide the battery onto the bottom of the tool until it
clicks into place.
3. To remove the battery, press down the battery
release button (4) and slide the battery off the tool.

Switching on and off

• Switching on: Slide the trigger lock (6) to the right to unlock the power trigger (7).
The blade speed is controlled by the amount of pressure on the power trigger.
• Switching off: Release the trigger to switch the reciprocating saw off.
10