Transport; Shutdown; Maintenance And Care - Kärcher ICC 1S D Betriebsanleitung

For some bulk waste parts you may
have to briefly pull the lever totally to-
wards the rear.
Lock in the lever at pos. 1 for medium-
size waste (such as leaves).
Lock in the lever at pos. 2 for big size
waste (such as cans).
Note
Sand and stone chippings will not get
sucked in when the bulk waste flap is
raised.
Sweeping dry floors
To avoid deposits in the suction channel
and durst formation, the water supply to the
brush nozzles must be on.
Switch on the spray water.
Regulate the water quantity.
Sweeping damp or wet floors
Switch off the water supply to the brush
nozzles if there is practically no dust forma-
tion.
Switch-off spray water.
Emptying waste container
Danger
Risk of injury! While reversing, ensure that
there is nobody in the way, ask them to
move if somebody is around.
Danger
Danger of tipping. Place the machine on an
even surface during emptying.
Danger
Danger of tipping. Maintain the required
safety distance while emptying on dumps or
ramps.
Danger
Risk of injury! Switch off the suction blower
before emptying the waste container.
Danger
Risk of injury! When emptying the waste
container, care should be taken to ensure
that no persons or animals are within its
swivelling range.
Danger
Danger of crushing. Never reach into the
rod assembly for the drainage mechanism.
Switch off suction blower.
Raise the suction opening and the side-
brushes.
Lock parking brake.
Raise waste container.
Note
There is a warning sound signal when the
waste container is raised.
Lower waste container.
Note
There is a warning sound signal when the
waste container is lowered.
Emptying the waste container man-
ually (accessory)
Note
You need the attachment set 2.639-500 to
manually empty the waste container.
Raise waste container
During pumping, press the control lever
for "Raise/lower waste container" in
"Raise" position and keep it depressed.
Lower waste container
During pumping, press the control lever
for "Raise/lower waste container" in
"Lower" position and keep it depressed.
Turn off the appliance.
Switch off suction blower.
Switch off the spray water for side-
brushes and suction opening.
Raise the suction opening and the side-
brushes.
Lock parking brake.
Push in the engine speed adjustment
completely,
Turn ignition key to "0" and remove it.

Transport

Warning
The appliance must be secured against
slippage during transport.
Turn ignition key to "0" and remove it.
Lock parking brake.
Secure the appliance at the transport
eyelets using tension belts, ropes or
chains.
Secure the wheels of the machine with
wheel chocks.

Shutdown

If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
Park the sweeper on an even surface.
Raise the side-brushes to prevent the
bristles from being damaged.
Turn ignition key to "0" and remove it.
Secure sweeper to prevent it rolling
away, lock parking brake.
Fill fuel tank and close fuel cock.
Change the engine oil and the oil filter.
Drain off the cooling water if frost is ex-
pected and check whether there is ade-
quate anti-frosting agent.
Empty the water tank and the pipe sys-
tem.
Disconnect battery.
Charge battery approx. every 2 months.
Clean the inside and outside of the
sweeper.
Park the machine in a safe and dry
place.

Maintenance and care

General notes
First switch off the appliance and re-
move the ignition key before performing
any cleaning or maintenance tasks on
the appliance, replacing parts or switch-
ing over to another function.
Pull out the battery plug or clamp the
battery while working on the electrical
unit.
– Maintenance work may only be carried
out by approved customer service out-
lets or experts in this field who are famil-
iar with the respective safety
regulations.
– Mobile appliances used for commercial
purposes aer subject to safety inspec-
tions according to VDE 0701.
27
English