Kärcher ICC 1S D Betriebsanleitung Seite 33

Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
Lower side-brushes and allow them to
briefly rotate.
The side-brushes lift up.
Drive machine backwards.
Check sweeping mirror.
The width of the sweeping track should lie
between 40-50 mm.
Adjusting the sweeping track:
Adjust the sweeping track width by ad-
justing the stopper.
– Turning the screw in clock-wise direc-
tion: Sweeping track becomes smaller
– Turn the screw in anti-clockwise direc-
tion: Sweeping track becomes bigger
Check sweeping mirror.
Replacing side brush
Lock parking brake.
The side-brushes lift up.
Loosen hand nuts.
Remove the wiper blade.
Fix in the new wiper blade.
Filling up the water tank
Unscrew the container lid.
Fill up the water tank:
Note
Do not insert the water hose to fill the water
tank (avoids water getting sucked back in).
Water level indicator for the water tank
Emptying the water tank
Unscrew rear cover.
Close locking tap.
Loosen the union joint.
Open locking tap.
Note
Ensure that the water flowing out does not
cause any damage.
Cleaning and replacing the water filter
Unscrew rear cover.
Close locking tap.
Loosen the union joint.
Unscrew the water filter casing.
Clean or replace the water filter.
Clean the water filter casing.
Check rubber washers.
Cleaning the spray nozzles on the side-
brushes
Unscrew the covering nut.
Pull out the spray nozzle.
Remove washer ring.
Clean the spray nozzle.
1 Union joint
2 Spray nozzle
3 Washer ring
Adjust suction opening
Drain off the suction opening.
Loosen the fastening screws on the
sides of the rollers.
Adjust the rollers using the adjustment
screw in such a way that the side-strips
touch the floor at the front and have a
clearance of 18 mm at the rear.
Tighten the fastening screws of the roll-
ers.
Raise suction opening.
Note
You need to replace the rollers if they can-
not be lowered up to the floor.
Replace sealing strip of suction opening
Drain off the suction opening.
33
English