Oil Change; Troubleshooting - Kärcher HDS 2000 Super Bedienungsanleitung

Clean fuel tank.
 Remove the appliance hood, the handle
bow and the lid of the switch box.
 Remove the tank.
 Dispose off fuel residues according to
environment safety laws.
 Rinse the tank thoroughly and let it dry.
 Change fuel filter.
Check pump for leaks
3 drops per minute are permitted and can
come out from the lower side of the appli-
ance.
 With stronger leak, have device
checked by customer service.

Oil change

ATTENTION
Risk of damage! In case of lacteous oil in-
form Kärcher customer service immediate-
ly.
 Ready a catch bin for appr 1 Litre oil.
 Loosen release screw.
Dispose of old oil ecologically or turn in at
a gathering point.
 Tighten release screw.
 Fill oil slowly up to the MAX marking on
the oil tank.
Note: Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions.
Clean sieve in front of the water
shortage safe guard
 Unscrew the hose from the pump head
to the safety block.
 Screw the bolt M8 into the bore of the
sieve and pull the sieve out.
 Clean sieve.

Troubleshooting

DANGER
Risk of injury by inadvertent start-up of ap-
pliance and electric shock. Prior to all work
on the appliance, switch off the appliance
and pull the power plug.
Indicator lamp "Fault" glows
 Open the covering flap of the storage
compartment.
 Read the electronic fault display.
 Remediate the fault as described below.
Display
Troubleshotting
 Increase water flow quantity.
 Clean the sieve in the water connection.
 Clean sieve in front of the water short-
age safe guard.
Display
Troubleshotting
 Replace the reed switch of the water
shortage safeguard (Customer Service).
 Clean the water shortage safeguard
(Customer Service).
Display
Troubleshotting
 Remove leaks in the high pressure sys-
tem.
Display
Troubleshotting
 Remove the soot from the heating coil
(Customer Service)
 Adjust burner (Customer Service)
 Replace the exhaust thermostat (Cus-
tomer Service).
Display
Troubleshotting
 Check the fuses and the voltage of all
three phases (Customer Service).
 Replace the air pressure switch (Cus-
tomer Service).
– 10
EN 29