Operating with cold water
Set the appliance switch the symbol
"Cold Water".
Operating with hot water
We recommend the following cleaning tem-
peratures:
– Light contaminations
30-50 °C
– Contaminations containing protein, i.e.
in the food processing industry
max. 60 °C
– Vehicle cleaning, machine cleaning
60-90 °C
DANGER
Scalding danger!
Set temperature regulator to desired
temperature.
Set the appliance switch the symbol
"Hot Water".
Note: Changing the working pressure and
the feed volume will also change the water
temperature.
Interrupting operation
Release the pulling lever; the device will
switch off.
Secure the trigger gun. To do so, push
the safety catch towards the front.
Release the trigger gun. To do so, push
the safety catch towards the back.
Release the pulling lever again; the de-
vice will switch on again.
If the hand-spray gun is not closed or
opened for more than 30 minutes, the
pump is automatically switched off for safe-
ty reasons.
Switch the machine switch off and back
on to take the machine into operation.
After operation with detergent
Set dosing value for detergent to "0".
Set the appliance switch the symbol
"Cold Water".
Open the hand spray gun and rinse the
appliance for at least 1 minute.
Turn off the appliance
DANGER
Danger of scalding from hot water! After op-
eration with hot water, the device must be
operated with openend handgun with cold
water for at least two minutes.
Shut off water supply.
Open the hand spray gun.
Switch on the pump with the power
switch and allow to run for about 5-10
seconds.
Close the hand spray gun.
Set the appliance switch to "OFF".
Pull main plug out of socket with dry
hands only.
Remove water connection.
Activate hand spray gun until device is
pressure less.
Secure the trigger gun. To do so, push
the safety catch towards the front.
Frost protection
ATTENTION
Risk of damage! Frost will destroy the appli-
ance if the water has not been completely
drained.
Store in a frost free area.
If the device is connected to a chimney, the
following must be observed:
ATTENTION
Threat of damage by penetrating cold air
through the chimney.
Disconnect device from chimney when
outside temperature drops below 0 °C.
If it is not possible to store frost free, shut
down device.
For longer work breaks or if a frost free stor-
age is not possible:
Empty detergent tank.
Drain water.
Flush device with anti-freeze agent.
– 8
EN
Shutdown
27