Fill In Liquid Softener; Water Connection; Power Connection - Kärcher HDS 2000 Super Bedienungsanleitung

Fill in liquid softener

– The liquid softener prevents the calcifi-
cation of the heating spiral while operat-
ing with calciferous tap water It is dosed
into the swimmer tank drop by drop.
– The metering is set to medium water ri-
gidity by the manufacturer
– This setting can be adjusted to local
conditions by customer service.
Note: A sample bundle of liquid softener is
included in the delivery.
 Fill in liquid softener RM 110 into the fill
vent for liquid softener (white tank).
Working without liquid softener
When working with soft water (such as rain
water), you can work without liquid soften-
er.
 Remove the lid from the vent opening
for liquid softener.
 Insert the included spring onto the lid
support.
 Replace the lid.
Note: This will prevent the indicator lamp
for the liquid softener from blinking per-
manantly.
Note: When working with tap water, this
spring will have to be removed again.
Refill detergent
DANGER
Risk of injury!
– Use Kärcher products only.
– Under no circumstances fill solvents
(petrol, aceton, diluting agent etc.)
– Avoid eye and skin contact.
– Observe safety and handling instruc-
tions by the detergent manufacturer.
Kärcher offers an individual cleaning
and care appliances program.
Your dealer will consult you gladly.
 Refill detergent.
24

Water connection

For connection values refer to technical
specifications.
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4") to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
Note: The supply hose is not included.
Suck in water from vessel
If you want to suck in water from an exter-
nal vessel, the following modification is
necessary:
 Remove the water connections from the
pump heads.
 Unscrew the upper supply hoses to the
swimmer tanks and connect them to the
pump heads.
 Connect suction hose (minimum diame-
ter 3/4") with filter (accessory) to the
water connection point.
Until the pump sucked in water, you should:
 Set the pressure/quantity regulation to
maximum quantity.
 Close the dosing valve for the detergent.
DANGER
Risk of personal injury or damage! Never
suck in water from a drinking water contain-
er. Never suck in liquids which contain sol-
vents like lacquer thinner, petrol, oil or unfil-
tered water. The sealings within the device
are not solvent resistant. The spray mist of
solvents is highly inflammable, explosive
and poisonous.

Power connection

– For connection values, see technical
data and type plate.
– The electrical connections must be
done by an electrician according to IEC
60364-1.
DANGER
Risk of injury on account of electric shock!
– Unsuitable electrical extension cables
can be hazardous. Only use electrical
extension cables outdoors which have
been approved and labelled for this pur-
pose and have an adequate cable
cross-section.
– 5
EN