Cleaning And Care; Maintenance; First Engine Oil Change; Initial Inspection After 8 Operating Hours - Kärcher KMR 1550 B Bedienungsanleitung

KMR 1550 B

Cleaning and care

Maintenance

Operating instructions for users
Before you carry out any cleaning or general maintenance tasks,
n Park the sweeper and switch off the engine.
Cleaning the inside of the sweeper:
You can clean out the inner parts of the sweeper by blowing them through
with compressed air.
Cleaning the outside of the sweeper:
The outside of the sweeper can be wiped off with a damp cloth. Do not use
any aggressive cleaning agents which might cause damage to the plastic
components.

First engine oil change

Caution!
When an engine is new, it is subject to increased abrasion. In order that the
engine does not suffer any damage, we recommend that you change the
engine oil and the oil filter after the first 8 operating hours.

Initial inspection after 8 operating hours

Caution!
In order to ensure that your sweeper functions safely and reliably, it should
undergo an initial inspection after approx. 8 operating hours. The inspection
should be carried out by an authorised service agent.
n Inspect all Bowden cables and adjust them if necessary.
n Replace the hydraulic fluid filter.
n Change the engine oil.
n Check that no hydraulic components are leaking and that they all function
correctly.
n Check that the handbrake functions correctly.
n Check the tyre pressure (specified value: 8 bar)

Daily maintenance

n Check the engine oil level.
n Check the hydraulic fluid level and top up if required.
n Check the tyre pressure (specified value: 8 bar).
n Inspect the brush roller for string, rope, etc. which may have been caught
up and remove it if necessary.
n Inspect the dust filter and if it is very dirty, shake it clean.
n Empty the dirt container.

Maintenance intervals

Keep to the service intervals set out in the maintenance booklet so that your
sweeper functions reliably and you retain the full benefit of the warranty.
The maintenance booklet 5.950-047 can be found in the tool compartment on
the sweeper (under the bonnet).
The necessary maintenance tasks should be carried out by an authorised
service agent.

Safety information applicable to maintenance tasks

Caution!
Before you begin any maintenance tasks, please read the enclosed leaflet
Safety Information No. 5.956-250.
English
33