Product Overview; Intended Use; Using The Machine - EINHELL FQ-SKS235 Bedienungsanleitung

Product overview

1 Motor
2 Machine head
3 Handle
4
Guard
5
Chain stopper screw
6 Chain stopper
7 Vise
8 Chain lock lever
9 Vise angle scale
10 Vise lock knob
11 ON/OFF switch
12 Cutting depth screw
13 Cutting angle lock knob
14 Cutting angle scale
15 Grinding wheel
16 Machine base
17 Table mount
18 Chain bar

Intended Use

The machine is intended for sharp-
ening chainsaw chains specified in
technical data.
Any other use or modification to the
machine is considered as improper
use and could cause considerable
dangers.
The appliance is not intended for
commercial use.
Installation
1
Install the machine base 16 to a
level and stable work surface,
using the table mount screw
kit: M8x100 screws, washers
and nuts.
EN
136

Using the machine

Caution! Make sure the grind-
ing wheel has a smooth
round shape.
1. Take the steps S1-S8.
2. Raise the machine head 2.
3. Press the green I (on) button 11 to
switch the machine on.
4. Wait until the grinding wheel has
reached full speed.
5. Slowly lower the machine head 2
and sharpen the first right cutter.
6. Raise the machine head 2.
7. Loosen the chain lock lever 8 and
pull the chain until the next right
cutter appears (every two cut-
ters).
8. Pull the chain to the left against
the chain stopper 6 and tighten
the chain lock lever 8. Slowly
lower the machine head 2 and
sharpen the remaining right cut-
ters with this adjustment.
9. Once all right cutters are sharp-
ened, press the red O (off) but-
ton 11 to switch the machine off.
10. To sharpen the left cutters, take
the steps S3-S8, but set the top
plate angle B on the vise in the
opposite direction.
11. Take the steps 2.-9. from these in-
structions in order to sharpen the
left cutters.
2
Install the machine head 2 to
the machine base 16 using the
cutting angle screw kit: M8x50
screw, washer and cutting an-
gle lock knob.