Parkside PTBM 500 D4 Originalbetriebsanleitung Seite 9

• Use protective equipment
- - Wear safety goggles.
- Use a dust mask for work which ge-
nerates dust.
• Connect a dust extraction device.
If connections are available for dust extrac-
tion and collection devices, make sure that
these are connected and properly used.
• Do not use the cable for purpo-
ses for which it is not intended.
Do not use the cable to pull the plug
from the socket. Protect the cable from
heat, oil and sharp edges.
• Secure the workpiece. Use jigs or
a vice to hold the workpiece securely.
This is safer than using your hand.
• Avoid abnormal body postures.
Ensure secure footing and keep your
balance at all times.
• Maintain tools with care
- Keep cutting tools sharp and clean
for better and safer working.
- Follow the instructions for lubrication
and changing tools.
- Regularly check the connection cable
of the power tool and, if it is dama-
specialist.
- Check extension cords periodically and
replace them if they are damaged.
- Keep handles dry, clean and free
from oil and grease.
• Remove the plug from the mains
socket when the power tool is not in
use, before maintenance and when
changing tools such as saw blades,
drill bits, cutters.
• Do not allow any tool keys to
remain inserted. Check, before swit-
ching on, that keys and adjusting tools
have been removed.
• Avoid unintentional starting.
Make sure that the switch is off when
inserting the plug into the socket.
G B
• Use extension cables outdoors.
Only use approved and appropriately
marked extension cables outdoors.
• Pay attention at all times. Pay
attention to what you are doing. Work
using common sense. Do not use the
power tool if you cannot concentrate.
• Check the power tool for possib-
le damage
- Before further use of the power tool,
safety devices or slightly damaged
parts must be carefully examined in
respect of their proper and intended
function.
- Check that the moving parts are wor-
king properly and are not jammed
or whether parts are damaged. All
satisfy all conditions to ensure the
proper operation of the power tool.
- Damaged safety equipment and
parts must be repaired properly or
replaced by an authorised specialist
workshop unless otherwise indicated
in the instructions.
- Damaged switches must be replaced
at a customer service workshop.
- Do not use power tools if the switch
cannot be turned on and off.
• CAUTION! The use of other bits and
other accessories can result in a risk of
personal injury.
• Have your power tool be re-
paired by a qualified electrician
- This power tool complies with the
relevant safety regulations. Repairs
electrician, using original spare parts;
otherwise accidents involving the user
may result.
CY
I E N I
9