Assembly; Operation - Parkside PTBM 500 D4 Originalbetriebsanleitung

• Do not use the power tool with
a damaged cable. Do not touch
the damaged cable and pull
the mains plug if the cable is
damaged while working. Dama-
ged cables increase the risk of electric
shock.
• The device is unsuitable for processing
of foods.
• Edit not work pieces that you can not
sure retain. Especially round or uneven
workpieces.
• Avoid abnormal body postures.
Ensure secure footing and keep your
A
balance at all times.

Assembly

K
The bench drill is supplied disassembled.
Clean the column tube (14), baseplate (17),
drilling bench (20), vice (23) and the drill
U
chuck (4) beforehand, with a dry cloth.
1. Place the column tube (14) on the ba-
seplate (17). Bolt the column tube (14)
to the baseplate (17) with the three as-
sembly srews (16) supplied. Tighten the
assembly srews (16) moderately tight
so that the threads in the baseplate (17)
do not strip.
2. Place the drilling bench (20) on the co-
lumn tube (14). Push the drilling bench
(20) into a lower position. Use the
bench (20) in a lower position.
B C
3. Place the vice (23) on the drilling
20
the drilling bench (20) by means
of the enclosed assembly screws
L M
(22) together with the washer
and the lock washer in the order
as shown.
V W
A
K
U
A B
K L
U V
B C
L M
V W
5
D E
N O
X Y
B C
4. Place the motor unit (13) on
L M
V W
C D
5. Bolt the three drill lifting arms
M N
6. Release the clamping screw from
W X
D E
7. Put the safety device (6) on the
N O
8. Secure the safety device (6) with
X Y
9. Fold the safety device (6) up-

Operation

Caution! Risk of injury!
- All hoods and protective devices
F G
- Disconnect the mains plug be-
P Q
Z
G B
I E
D E
the column tube (14). Secure
the motor unit (13) with the two
clamping screws (27) on the
N O
side using the enclosed Allen key
(25).
X Y
E F
into the spindle guide (9). Tigh-
ten the three hole lifting arms
with a spanner (AF 6 mm). O P
the depth stop (8).
Y Z
F G
upper part of the drill spindle
(7).
P Q
the clamping screw (28).
Z
wards. Insert the chuck (4) on
the taper of the drill spindle (7).
Push the drill chuck onto the drill
chuck tip with a few light taps.
Use a plastic hammer for this
purpose.
space in which to work and that
you do not endanger other peo-
ple.
H I
must be assembled properly be-
fore commissioning.
fore changing the setting on the
R S
device.
CY
N I
F G
P Q
Z
G H
Q R
H I
R S
J
T
1 1
H
R
I
S
J
T