Herunterladen Inhalt Inhalt Diese Seite drucken

Nova ARGON Betriebshandbuch Seite 49

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

49
The lines of the NOVA ARGON are made of an inner core of Polyethyl-
ene and an outer sheath of Polyester. Any over stretching of lines apart
from the strain imposed during normal flight, should be avoided as over
stretching is irreversible.
Ensure that the lines are not folded tightly. It's extremely important to
avoid any kinking of the lines, especially the main lines.
Prevent lines from catching on anything as they may be over stretched.
Do not step onto the lines.
Keep the canopy and lines clean as dirt may penetrate into the fibre and
shorten the lines or damage the cloth.
Be careful, not to allow snow, sand or stones to enter inside the canopy's
cells: the weight can brake, or even stall the glider, as well as the sharp
edges can destroy the cloth!
Uncontrolled strong wind takeoffs or landings can result in the leading
edge of the canopy hitting the ground at high speed which may cause
rips in the profile and damage the rib material.
The brake line can chafe badly if tangled with another line.
Check line length after tree or water landings. They can stretch or shrink
lines.
Clean the paraglider with fresh water after contact with salt water. Salt
water crystal can weaken line strength, even after rinsing in fresh water.
Replace lines immediately after contact with salt water. Also check
canopy material after water landings, as waves can place uneven forces
and cause cloth to distort in specific areas. Always remove gliders from
the water by holding only the trailing edge.
A line plan is enclosed in this operators manual or may be requested
from the manufacturer or importer.
Do not always fold the canopy symmetrically to the centre cell as this
can cause constant stress on the centre cell (centre cell always to the
outside).
You should arrange an annual inspection of the NOVA ARGON to be
carried out by the manufacturer or distributor.
The DHV requires a two yearly maintenance check. A DHV-stamp is
required to confirm the check, otherwise the Gutesiegel certification is
rendered invalid.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis