Fitting Or Changing The Cut-Off Wheel; Clamping The Workpiece - struers Discotom-5 Gebrauchsanweisung

Fitting or Changing the
Cut-off Wheel

Clamping the Workpiece

10
Discotom-5
Instruction Manual
Note: The spindle for Discotom-5 is left-hand threaded. If
Discotom-5 has been used for manual cutting, fasten the
cutting handle with the black handle at the right hand side of
the machine before changing the cut-off wheel.
Press and hold down the black locking knob on the right-hand
side of the cut-off wheel, turning the cut-off wheel until the
spindle lock clicks.
Remove the nut with a fork spanner. Remove the flange and
the old cut-off wheel.
Mount the new cut-off wheel.
Conventional cut-off wheels based on Al
between two cardboard washers, to protect the cut-off wheel.
For maximum precision with diamond or CBN cut-off wheels, do not use
Mount the flange and the nut. Tighten carefully and release
the locking knob.
Place the workpiece between the quick clamping device and the
spring clamp, and the back stop.
Push the clamps towards the workpiece and lock the quick-
clamping device with the locking handle.
The workpiece must be firmly held in the quick-clamping device.
Carefully close the protection guard.
IMPORTANT
O /SiC abrasives should be placed
2 3
cardboard washers.
IMPORTANT