Resetting The System (Reconfiguration) - WABCO Compact Tester Bedienungsanleitung

GB
6. Resetting the System
(Reconfiguration)
The ABS system can be made to once
again recognize the components con-
nected to it (ASR, engine control). The
new status is stored in the parameters
of the ECU. This function is available
only for ABS-D systems.
The reconfiguration is activated by
pushing the following buttons:
• Push <SYSTEM> button and re-
lease.
• System (e.g. '4 - 2') is being dis-
played.
• Push <SYSTEM> button for longer
than 2 seconds.
26
The display is deleted and after a short
delay the type of ECU identified will ap-
pear again. The reconfiguration process
is now complete. Now the ignition
should be switched off and on again,
and then the menu item 'error search'
selected.
If for any reason the control unit does
not support the reconfiguration proce-
dure, the display will show '---' immedi-
ately after the <SYSTEM> button has
been pushed for the second time. In this
case, no reconfiguration can be per-
formed.