Steam Ironing - Silvercrest SDBS 2200 A1 Bedienungsanleitung

Steam ironing

GB
36
♦ Press the on/off button
On/off button and the "Iron dry" indicator
♦ Press the boiler button
the boiler button
NOTE
The boiler is located in the bottom of the appliance and is automatically supplied
with water from the water tank
and refi lling the boiler, the pump switches on for a few seconds. This causes a
humming noise and you will feel the appliance vibrate. This is normal and is
not a reason for complaints.
♦ After a few minutes, the "Steam ready" indicator
♦ Turn the temperature control
NOTE
For steam ironing you must set at least the medium temperature ● ● on the
temperature control
♦ The temperature indicator
As soon as the temperature indicator
been reached and you can start steam ironing.
♦ Set the steam control
clockwise to increase the amount of steam. Turn it in the opposite direction
to reduce the amount of steam.
♦ If the iron is fi xed to the base station
catch release into the
from the base station
♦ While ironing, you can press the steam blast button
blast of steam from the soleplate
button to stop the steam output.
NOTE
If you only want a short steam blast, press the Steam stop button
and then release it. The steam only comes out of the soleplate
you hold down the button and stops when you release it.
to switch on the appliance. The indicator in the
to activate steam ironing mode. The indicator in
lights up, and the "Iron dry" indicator
by means of a pump. During heating up
to set the desired ironing temperature.
.
lights up while the appliance is heating up.
goes out, the set temperature has
to the desired steam setting. Turn the control
position. Now you can remove the iron
.
onto the clothes. Press the Steam stop
light up.
goes out.
lights up.
using the catch , push the
to give a continuing
briefl y
as long as
SDBS 2200 A1