Troubleshooting; Safety Guidelines; Fault Causes And Rectifi Cation - Silvercrest SDBS 2200 A1 Bedienungsanleitung

■ Use a funnel to add some water to the boiler and rinse it through several
times.
■ After you have emptied the boiler again, screw the Calc / Lock / Safe screw
cap

Troubleshooting

This section contains important information on fault identifi cation and rectifi cation.
Observe the instructions in order to avoid risks and damage.

Safety guidelines

WARNING
Observe the following safety information to avoid risks and property damage:
► Repairs to electrical appliances should only be carried out by specialists
trained by the manufacturer. Improper repairs can cause considerable risks
to users and damage to the appliance.
Fault causes and rectifi cation
The following table will help to identify and rectify minor faults:
Fault
The appliance is
not working.
The appliance
produces no/too
little steam.
SDBS 2200 A1
back into the thread and tighten it hand-tight.
Possible cause
Fault with the power supply.
The appliance is not switched on. Switch the appliance on using
There is not enough water in the
water tank .
The appliance is not suffi ciently
hot.
The steam control is set to
minimum.
Remedy
Check whether the mains plug
is fi rmly in the socket.
the on/off switch .
Fill the water tank with water.
Wait until the "Steam ready"
indicator lights up.
Turn the steam control
clockwise.
GB
39