Safety; Export - ergoline Evolution 500 Gebrauchsanweisung

Please read and observe ...

Safety

Danger!
Assembly and electrical connection must comply with the na-
tional regulations. 1)
Assembly, installation, upgrading or repair of the device may
only be carried out by specially trained and instructed person-
nel.
• All danger and safety notes attached to the device must be observed!
• No safety equipment (e.g. panel switch) or safety notes may be re-
moved or deactivated which can impair the safe operation of the de-
vice!
• The device may only be operated in proper condition!
• The device operating time must be controlled with a timing device in
accordance with the standards EN 60335-2-27 and A1 2000 Section
22.108 and 22.109. This timing device must be designed so that the
device is automatically switched off at the latest after <110% of the
selected operating time even when the controller fails.
• Do not change, obstruct or block the air inflow and outflow area to the
device or make any unauthorised changes to the device. The manu-
facturer shall bear no liability for damage or injuries resulting from
such actions.
1) In Germany: VDE regulations
40
• Before putting a tanning device into operation, the transport pallet
must be removed from under the device. Danger of overheating by
obstruction of the air routing.
Caution!
The code for access via the infrared interface is preset in the
software of the hand-held unit, and can therefore be used with
any unit. Anyone, who downloads the software from the Internet
can access the unit date with a hand-held unit. Please note that
Customer Service changes the preset access code during initial
start-up – see page 139. Please note the new code for future
use!
This code is independent of the access code for the presettings
via the control panel.

Export

We emphasise that these devices are intended for the European market
and must not be exported to nor operated in the USA or Canada!
The manufacturer shall assume no liability whatsoever in case of non-ob-
servance! We explicitly emphasise that high liability risks may occur for
the exporter an/or the operator in case of non-observance.