Changing Presettings With The Control Panel - ergoline Evolution 500 Gebrauchsanweisung

Changing presettings with the control panel

The setting mode enables you to call up operating states and make alte-
rations to current settings. If VoiceGuide is included with the device, you
can also listen to the explanations on the preadjustments.
Changing to Presetting mode
• Press the buttons – and + simultaneously for at least five seconds
outside a tanning process.
• appears in the display.
• Enter the code (see Page 138).
• Press the START/STOP button four times when you run the Preset-
ting mode for the first time.
• briefly appears in the display, then
and the presetting value are displayed alternately (see column "On
delivery").
• By pressing the + button you scroll up to the next function (from -01-
to -35-).
• By pressing the – button you scroll down to the next function (from
-35- to -01-).
Changing presettings
Increase the preset value:
• Press and hold the START/STOP button while simultaneously pres-
sing the + button.
Decrease the preset value:
• Press and hold the START/STOP button while simultaneously pres-
sing the – button.
Reset to the last value set:
• Press the START/STOP button.
Reset to the delivered state:
• See function
(Function 1)
Note:
The sunbed will automatically return to 'idle' mode 30 se-
conds after the last button was pressed.
The presettings are listed beginning on Page 140.
.
137