Changing Presettings With A Hand-Held Unit - ergoline Evolution 500 Gebrauchsanweisung

Changing presettings with a hand-held unit

Some data can also be displayed and changed with a commercially
available hand-held unit (e.g. from Palm). For this purpose you require
special software (available in German and English), which you can down-
load at www.ergoline.de. The operating manual for this software is also
available at the same website.
Caution!
The code for access via the infrared interface is preset in
the software of the hand-held unit, and can therefore be
used with any unit. Anyone, who downloads the software
from the Internet can access the unit date with a hand-held
unit. Please note that Customer Service changes the preset
access code during initial start-up – see software operating
manual. Please note the new code for future use!
This code is independent of the access code for the preset-
tings via the control panel.
Note:
Please read the operating manual for the Ergoline software
for instructions on how to display or change data with a
hand-held unit.
Information on operating the hand-held unit is contained in the manufac-
turer's documentation.
IR Function
04002 / 0
139