Appliance-Specific Safety Instructions; Before Use; Fitting The Tool Rests - Parkside PDFW 120 A1 Originalbetriebsanleitung

■ Use an extension cord for outdoor use! Use
only suitably certified and labelled extension
cords outdoors.
■ Remain alert at all times! Pay attention to what
you are doing. Proceed with caution when
working with the tool. Do not use the power tool
when distracted.
■ Check the power tool for any damage! Before
continuing to use the power tool, check all safety
devices and any slightly damaged parts to make
sure they function properly and as intended.
■ Check that all moving parts work properly with-
out jamming and whether parts are damaged.
All parts must be properly fitted and meet all
the conditions to ensure the proper operation of
the power tool. Damaged safety devices and
parts must be properly repaired or replaced
by a specialist workshop unless otherwise indi-
cated in the instructions.
■ Damaged switches must be replaced at an
authorised customer service centre.
■ Do not use any power tools that you cannot
switch on and off with the power switch.
CAUTION! The use of other tools and accesso-
ries could lead to an increased risk of personal
injury for you.
■
Have your power tool repaired by a qualified
electrician! This power tool complies with all
relevant safety regulations. Repairs may only
be performed by a qualified electrician using
original spare parts; otherwise this could lead
to accidents for the user.
Appliance-specific safety instructions
WARNING!
► Do not use damaged or deformed discs or
brushes.
■ Use only grinding discs and brushes whose
imprinted speed rating is at least as high as that
on the type plate on the power tool.
■ Adjust the spark deflector occasionally to com-
pensate for wear on the disc. Ensure that the
distance between the spark deflector and the
disc is a small as possible and is never more
than 2 mm.
GB │ IE │ NI │ CY
■ 10
│
■ Always leave the tool attached to the spindle
to reduce the risk of contact with the rotating
spindle.
Residual risks!
Even if you operate this power tool properly, there
will still be residual risks. The following risks can
occur in the context of the design and construction
of this power tool:
a) Lung damage, if no suitable breathing protection
is worn.
b) Hearing damage, if no suitable hearing protec-
tion is worn.
c) Damage to health caused by vibrations if the
appliance is used for extended periods or is not
properly used and maintained.
WARNING!
► The power tool creates an electromagnetic
field during operation. This field can, in certain
circumstances, impair active or passive medical
implants. To reduce the risk of fatal injuries, we
recommend that people with medical implants
consult their doctor and the manufacturer
of the medical implant before operating this
machine.

Before use

NOTE
► Please note that you must always fit
-- the tool rests ,
-- the spark deflectors
-- and the eye shields
as required for the grinding
► Please note that you will require tools which
are not included in delivery for the assembly.

Fitting the tool rests

Fit the tool rests onto the device using the supplied
knurled screws (See fig. B):
♦ Hold the relevant nut into the appropriate recess
with a finger.
or buffing disc .
PDFW 120 A1