Grinding; Changing The Grinding Disc/Buffing Disc; Fitting The Flexible Shaft; Fitting Tools Onto The Flexible Shaft - Parkside PDFW 120 A1 Originalbetriebsanleitung

Grinding

♦ Place the workpiece on the tool rest
the workpiece slowly towards the grinding disc
at the required angle until the workpiece
and the grinding disc
each other.
♦ Move the workpiece evenly backwards and
forwards in order to achieve optimal results. This
also ensures that the grinding disc
down more evenly.
Changing the grinding disc/buffing disc
WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
WARNING!
► The grinding or buffing disc
not be any larger than the prescribed diameter.
► Replace the grinding
when the outer diameter is less than 50 mm.
NOTE
► Please note that you will require tools which
are not included in delivery for the assembly.
♦ Using a Phillips screwdriver, unscrew the fixing
bolts from the side protective covers
E). Remove the protective covers
♦ If you want to change the buffing disc
screw the attachment for the flexible shaft
using a 13 mm wrench.
♦ Unscrew the union nut
using a 17 mm wrench. Hold the affected grind-
ing or buffing disc
create a suitable counterpressure.
♦ Remove the tension disc
or buffing disc .
♦ Place the new grinding
the shaft .
♦ Push the tension disc
nut back onto the shaft
GB │ IE │ NI │ CY
■ 12
│
. Guide
come into contact with
is worn
used may
or buffing disc
(see fig.
on both sides.
, un-
from the shaft
firmly in one hand to
and grinding
or buffing disc on
and screw the union
.
♦ Re-tighten the union nut
or buffing disc that you have just attached
firmly in one hand to create a suitable counter-
pressure.
WARNING! RISK OF INJURY!
► Never use the grinding
without the protective cover
CAUTION! PROPERTY DAMAGE!
► Do not tighten the union nut
since the grinding disc
break.
♦ Refit the protective cover
by tightening the fixing screws
Fitting the flexible shaft
WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
♦ Screw the flexible shaft
thread of the appliance. To do this, push the
axle core of the flexible shaft into the square
hole on the connecting thread
ing nut anticlockwise to tighten it.
WARNING – RISK OF INJURY!
► Make sure that the eye shields
down to the tool rests
unintentional contact with the grinding
buffing disc .
► After use, remove the flexible shaft
the appliance. Otherwise, the flexible shaft
could start thrashing about in an uncon-
trolled manner and cause an injury when you
switch the appliance on.
Fitting tools onto the flexible shaft
♦ Push the black collar
the flexible shaft
that the collet chuck mount
anticlockwise direction. Hold the black collar
in this position.
. Hold the grinding
or buffing disc
.
too tightly
could otherwise
and fix it in place
.
onto the connecting
. Turn the lock-
are folded
. This can prevent
from
all the way back onto
to lock the spindle. Note
is loosened in an
PDFW 120 A1
or