Scheppach HC70 Originalbetriebsanleitung Seite 26

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system due to failure to
observe the national electrical requirements and
regulations
Note:
The operating manual is part of the product and contain
important information for safe, proper and economical
operation. Please also observe the applicable national
regulations. Read all operating and safety instructions
carefully before use and only use the product as de-
scribed. Keep the manual and pass it on when you give
the product to someone else.
2. Proper use
The compressor is used to generate compressed air
for pneumatically powered tools that can be operated
with an air rate of up to 105 l/min. (e.g. tyre inflators, air
blow guns, paint spray guns).
The compressor may only be operated in a dry and
well ventilated indoor space.
The product may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
An element of the intended use is also the observance
of the safety instructions, as well as the assembly in-
structions and operating information in the operating
manual.
Persons who operate and maintain the product must be
familiar with the manual and must be informed about
potential dangers.
26 | GB
The liability of the manufacturer and resulting damages
are excluded in the event of modifications of the product.
The product may only be operated with original parts
and original accessories from the manufacturer.
The safety, operating and maintenance specifications of
the manufacturer, as well as the dimensions specified in
the technical data, must be observed.
Please note that our products were not designed with
the intention of use for commercial or industrial purpos-
es. We assume no guarantee if the product is used in
commercial or industrial applications, or for equivalent
work.
The manufacturer is not liable for damage caused by
improper use or incorrect operation.
3. Product description (Fig. 1-14)
1. Air filter cover
1a. Air filter
1b. Air filter housing
1c. Screw
1d. Transport plug
2. Safety valve
2a. Perforated drain nut
2b. Safety connection
2c. Cap
3. Pressure regulator
4. Manometer (set pressure)
4a. Manometer (vessel pressure)
5. Pressure vessel
5a. Transport handle
6. Foot
6a. Screw
6b. Washer
7. Drain plug (condensation water)
8. Wheel
8a. Screw
8b. Washer
9. Compressor pump
9a. Oil-level window
9b. Oil drain screw
9c. Oil sealing plug
9d. Transport plug
9e. Oil filling opening
10. Transport handle
11. Pressure switch
11a. On/off switch
12. Quick coupling
13. Compressor oil
www.scheppach.com