Before Commissioning - Scheppach Acs4000 Originalbetriebsanleitung

9.1 Suitable materials and paints
Many materials and paints are suitable for spraying, but
some are not. See the manufacturer's recommenda-
tions for this.
The following materials and paints are approved:
• Water-based paints
• Wood preservative
• Oil based paints
• Primers
• Enamel paints
• Adhesive primers
• Clear lacquers
• Oils
• Pickling substances
9.2 Unsuitable materials and paints
When using the following materials and paints, prema-
ture wear and clogging of the variable nozzle will occur.
This will invalidate the warranty.
a. Paints and varnishes containing abrasive compo-
nents, such as:
• emulsion/dispersion paints for exterior use
b. Silicate paints
c. Combustible materials
For excellent results, read the instruction manual care-
fully before using your airless paint spray system.
9.3 Preparation of the material to be sprayed
The product can be used to spray diluted water-based
paints and varnishes. For detailed information, please
refer to the technical data sheet provided by the paint
manufacturer (> Internet download).
• Stir the material thoroughly and dilute it in the con-
tainer in accordance with the dilution recommenda-
tion. The use of a stirrer is recommended for stirring.
Recommended dilution
Water-dilutable paints and primers
Water-dilutable interior wall paints
* The values stated in the dilution recommendation are
guidelines.
The optimum dilution for the material used must be de-
termined by a spray test.
Cleaning instructions
The product must be thoroughly cleaned after each use
and before prolonged breaks.
• Also observe the information in the operating in-
structions for interruptions in work (short interrup-
tions, chapter 11).
• For longer interruptions in work, see chapter 13 in
the operating instructions.
Preparing the spray surface
WARNING! Danger of electric shock due to penetrat-
ing spray material! Be sure to tape down sockets and
switches.
• Thoroughly cover a generous area around the area
to be sprayed. Any uncovered areas or surfaces
may otherwise become contaminated.
• Make sure that the spray surface is clean, dry and
free of grease.
• Roughen smooth surfaces and then remove the
sanding dust.
Spray technique
• Always keep the paint spray gun at the same distance
from the object and hold at a right angle. The ideal
spraying distance is approx. 20 - 25 cm. Move the paint
spray gun evenly with the whole arm (see Fig. 11).
• Determine the appropriate settings in each case by
trial and error, e.g. on a piece of cardboard.
• Do not switch the device on/off over the spray area,
but start and end the spraying process approx. 10
cm outside the spray area.

10. Before commissioning

m Attention!
Always make sure the product is fully assembled
before commissioning!
Assembly
Dilute You can assemble the device using two open-ended
5-10%*
spanners (not supplied). Alternatively, you can use a 16
mm and 19 mm spanner (not supplied).
Dilute
1-10%*
Connecting a high-pressure hose (Fig. 1, 2)
1. Fit the high-pressure hose 12 to the connection
thread (14) of the device. Tighten the nuts using
an open-ended spanner. Counter the nut of the
connection thread (14) with a second open-ended
www.scheppach.com GB | 31