Scheppach HC26Si Originalbetriebsanleitung Seite 20

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system due to failure to
observe the national electrical requirements and
regulations
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Product description (Fig. 1-6)
1. Transport handle
1a. Grub screw (transport handle)
2. Pressure switch
3. On/off switch
4. Air filter
4a. Screw (air filter)
4b. Filter element
20 | GB
5. Pressure gauge (set pressure can be read off)
6. Pressure regulator
7. Safety valve
8. Quick coupling (regulated compressed air)
9. Pressure vessel
10. Wheel
10a. Screw (wheel)
10b. Nut (wheel)
11. Drain screw for condensate
12. Foot
12a. Screw (foot)
12b. Nut (foot)
3. Scope of delivery
Item
1
4
10
12
4. Proper use
The compressor is used to generate compressed air
for pneumatically powered tools that can be operated
with an air rate of up to 100 l/min. (e.g. tyre inflators,
air blow guns, paint spray guns). Due to the limited air
output it is not possible to use the compressor to drive
tools with very high air consumption (for example or-
bital sanders, die grinders and hammer screwdrivers).
The compressor may only be operated in a dry and well
ventilated indoor space.
The machine may only be used in the intended manner.
Any use beyond this is improper.
The user/operator, not the manufacturer, is responsible
for damages or injuries of any type resulting from this.
Please note that our products were not designed with
the intention of use for commercial or industrial purpos-
es. We assume no guarantee if the product is used in
commercial or industrial applications, or for equivalent
work.
www.scheppach.com
Quantity Designation
1x Machine body
1x Transport handle
1x Air filter (pre-installed)
2x Wheel
1x Foot
1x Assembly material
1x Operating manual