Scheppach HC24 o Original Anleitungen Seite 67

manual.
Even when all safety measures are taken, it is not possi-
ble to exclude all remaining hazards. Due to the construc-
tion of the machine, the following risks can occur:
• Injury of the lung when no breathing mask is worn.
• Injury of the ear when no ear protection is worn.
• Injury of the eyes when no efficient goggles (or protec-
tive screen) are worn.
Warning:
If an air hose is broken off or damaged, the air input on
the compressor must be switched off. A broken air hose
that is not supported, is extremely dangerous and can
quickly start to rotate, hitting people or blowing foreign
bodies in the air.
Do not try to catch the hose. Instead, immediately remove
all spectators from the dangerous area, cut off the air in-
put, and switch the machine off by pressing the ON/OFF
switch. Then remove the hose from the compressor.
Unpacking
Due to modern series production it is improbable that
your compressor has any defects or that a part is miss-
ing. Should you note a fault, however, do not switch the
machine on before the parts are replaced or the fault has
been remedied. Not observing this instruction can lead to
serious injuries.
Assembly
Handle
The compressor handle is to be assembled as follows:
Wheels, Fig. 2
1 For fixing the wheels (12), first put one axle pin through
the wheel. Then place the spacer washer to the under-
side of the wheel.
2 Fasten the wheel unit through the hole in the bracket
underneath the tank.
3 Fasten the flat washer, the split washer, and the nut.
Tighten the nut from the underside of the wheel and
attach the wheel cover.
4 Repeat the procedure for the second wheel.
Rubber feet, Fig. 3
Fix the rubber feet to the bracket on the front of the tank
using the screws, washers and nuts supplied.
international 67