Disposal And Recycling; Troubleshooting - Scheppach Hc24V Originalbetriebsanleitung

15 Disposal and recycling

Notes for packaging
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
Notes on the disposal of electrical and electronic
equipment
Waste electrical and electronic equipment
does not belong in household waste, but must
be collected and disposed of separately!
• Used batteries that are not installed permanently in
the old device must be removed non-destructively be-
fore disposal! Their disposal is regulated by the bat-
tery act.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their personal
data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not be
disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:

16 Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your product failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Product does not run.
Product runs, but no pressure.
Product runs, pressure shown
on the manometer, but tools are
not running
Possible cause
Mains voltage not present.
Mains voltage too low.
Outside temperature is too
low.
Motor is overheated.
The safety valve leaks.
The seals are damaged.
The drain screw for conden-
sate leaks.
Hose connections leaking.
Quick-coupler leaking.
Pressure set too low at pres-
sure regulator.
www.scheppach.com
– Public disposal or collection points (e.g. municipal
works yards)
– Points of sale of electrical devices (stationary and
online), provided that dealers are obliged to take
them back or offer to do so voluntarily.
– Up to three waste electrical devices per type of de-
vice, with an edge length of no more than 25 centi-
metres, can be returned free of charge to the man-
ufacturer without prior purchase of a new device
from the manufacturer or taken to another autho-
rised collection point in your vicinity.
– Further supplementary take-back conditions of the
manufacturers and distributors can be obtained
from the respective customer service.
• If the manufacturer delivers a new electrical appliance
to a private household, the manufacturer can arrange
for the free collection of the old electrical appliance
upon request from the end user. Please contact the
manufacturer's customer service for this.
• These statements only apply to devices installed and
sold in the countries of the European Union and which
are subject to the European Directive 2012/19/EU. In
countries outside the European Union, different regu-
lations may apply to the disposal of waste electrical
and electronic equipment.
Remedy
Check cable, mains plug, fuse and socket.
Avoid extension cables that are too long. Use exten-
sion cables with sufficient conductor cross-section.
Do not operate at outside temperatures below +5°C.
Allow the motor to cool down. If necessary, remedy the
cause of the overheating.
Contact your local service centre. Only allow qualified
personnel to carry out repairs.
Check the seals and have any damaged seals re-
placed by a service centre.
Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
Check compressed air hose and tools, replace if nec-
essary.
Contact your local service centre. Only allow qualified
personnel to carry out repairs.
Turn up the pressure regulator further.
GB | 27