Herunterladen Diese Seite drucken

Scheppach HC24V Originalbetriebsanleitung Seite 26

Vorschau anzeigen Andere Handbücher für HC24V:
Verfügbare Sprachen

Verfügbare Sprachen

  • DEUTSCH, seite 1
12.2.2
Maintaining the pressure vessel (6)
(Fig. 9)
ATTENTION
To ensure a long service life for the pressure vessel,
drain off the condensate after each use by opening the
drain screw.
ATTENTION
The condensate from the pressure vessel contains oil
residue. Dispose of the condensate in an environmen-
tally friendly manner at a suitable collection point.
1. Release the vessel pressure beforehand (see 13.2.1).
2. Open the drain screw (6a) by turning it anti-clockwise
(looking at the screw from the bottom of the compres-
sor).
3. In order to drain the condensation water completely out
of the pressure vessel (6), it must be tilted slightly to the
side so that the drain screw (6a) is the lowest point.
4. Then close the drain screw (6a) again (turn clock-
wise). Check the pressure vessel (6) for rust and dam-
age each time before use.
5. The compressor shall not be operated if the pressure
vessel (6) is damaged or rusty. If you discover dam-
age, please contact the customer service workshop.
13 Storage and transport
WARNING
Danger of injury and burning!
The product can start unexpectedly and cause injuries.
– Switch off the engine before carrying out any clean-
ing or maintenance work.
– Allow the engine to cool down.
– Pull out the mains plug.
– De-pressurise the compressor.
Note:
Release overpressure in the compressor by switching off
the compressor and using up the compressed air still in
the pressure vessel, e.g. with a compressed air tool run-
ning at idle or with an air blow gun.
• Compressed air can cause serious injuries.
• Clean and check the product for damage.
13.1
Transport (Fig. 1)
• The product must be secured against tipping and slip-
ping during transport in vehicles in order to prevent
damage and injuries.
• Protect the product from impacts, shocks and severe
vibrations, e.g. during vehicular transport.
• Use only the transport handle (2) for transporting the
product.
13.2
Storage
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
26 | GB
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
ATTENTION
Pull out the mains plug and ventilate the compressor
and all connected compressed air tools. Store the com-
pressor in such a way that it cannot be used by unau-
thorised persons.
ATTENTION
Store the product only in dry locations that are inacces-
sible for unauthorised persons.
Do not tilt the unit, only store it upright!
13.2.1
Release overpressure in the compressor by switching off
the compressor and using up the compressed air still in
the pressure vessel, e.g. with a compressed air tool run-
ning at idle or with an air blow gun.
14 Repair and ordering spare parts
After repairs or maintenance, make sure that all safety-re-
lated parts are installed and are in perfect condition. All
parts which may cause injury must be kept where they
are inaccessible to children or others.
ATTENTION
According to the German Product Liability Act, no liabili-
ty is accepted for damage caused by improper repairs
or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialists. The same applies to
accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the front
page.
Connections and repairs
Connections and repair work on the electrical equipment
may only be carried out by electricians.
14.1
Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Compressed air accessory
set 13 pcs. - article no.:
Spiral hose - article no.:
14.2
Service information
With this product, it is necessary to note that the following
parts are subject to natural or usage-related wear, or that
the following parts are required as consumables.
Wearing parts*: Quick coupling connection, compressed
air accessories set, spiral hose
* = may not be included in the scope of delivery!
www.scheppach.com
Release excess pressure
7906100710
7906100711
loading

Diese Anleitung auch für:

59061179015906117903590611790459061179055906117996959061179977