ATIKA AMA 2500 Originalbetriebsanleitung Seite 16

M a i n t e n a n c e a n d
M a i n t e n a n c e a n d
•
Each time before starting maintenance work:
− Switch off the motor and pull out the mains plug.
− Wear protective gloves to prevent injury.
When the machine is stopped for purpose of mainte-
nance, storage or accessory replacement make sure
that the energy source is isolated and the mains plug is
disconnected. Make sure that all movable parts are
stationary and the key (if applicable) is removed. Allow
the machine to cool down before maintenance, adjust-
ment etc.
The cutters will not come to a standstill immediately
after cut-off. Before starting any service work wait until
all parts are stationary.
When performing maintenance operations on the cut-
ting tool be aware that it can still move due to the start
mechanism even if the motor does not run by the cover
interlocking.
Be sure to have removed any tools from the machine
after completion of service work.
T e c h n i c a l d a t a
T e c h n i c a l d a t a
Type/Model
Year of construction
Motor
Motor rating P S6 - 40 %
1
Motor rating P S1
1
Current consumption I
ON/OFF-switch with
Weight
Sound pressure level at work L
Measured sound power level L
Guaranteed sound power level L
Max. branch diameter
(only for freshly cut wood)
Safety class
Protection class
Mains fuse
Suisse
UK
14
c l e a n i n g
c l e a n i n g
AC-Motor 230 V~, 50 Hz, 2800 rpm, including automatic motor brake
Motor protection switch, electrical safety cut-out, zero-voltage initiator
PA
WA
WA
•
Generally garden shredders require little maintenance. To
maintain their efficiency and a long life, observe the fol-
lowing:
− Keep vent slits clean and free from obstructions.
− Check the locking screws (tighten where necessary).
− Clean the device after shredding.
To clean your product only use a warm moist cloth and a soft
brush.
Never use cleaning agents or solvents. Otherwise the device
may be damaged irreversibly. Plastic parts may be corroded
by chemicals.
− Do not clean the machine with running water or high-pressure
cleaners.
− After each operation treat bare metal parts with an environ-
ment-compatible biodegradable spray oil to protect them
against corrosion.
AMA 2300
see last page
2300 W
2000 W
10,4 A
83 dB (A) / K = 3 dB (A) (measured to 2000/14/EC)
107 dB (A) (measured to 2000/14/EC)
108 dB (A) (measured to 2000/14/EC)
∅ max. 40 mm
16 A time-lag
10 A time-lag
13 A time-lag
AMA 2500
2500 W
2000 W
11,3 A
18,5 kg
I
IP X4
16 A time-lag
13 A time-lag