Charging The Battery Pack - Parkside Pdsa D3 Bedienungs- Und Sicherheitshinweise

1. Fold up the battery cover
2. There are 2 different battery
compartments:
The upper battery compartment
–
is intended to be used with the
12 V battery pack.
The lower battery compartment
–
is intended to be used with the
20 V battery pack.
3. I
12 V: Insert the battery pack
–
fully into the upper battery
compartment
place.
20 V: Insert the battery pack
–
fully into the lower battery
compartment
place.
4. R
the release button
battery pack
[
battery pack.
˜ 20 V
information
˜ C
charging level
(Fig. H)
Check battery pack charge level:
o
Press the button
charging level LEDs
LED
Red/yellow/green
Red/yellow
Red
˜ C
(Fig. I)
NOTE
If the battery pack
u
Allow the battery to cool down
completely before charging.
.
[ ]
[
[ ]
until it clicks into
[ ]
[ ]
until it clicks into
[ ]
Press
/ on the
[ ] [ ]
/ . Pull out the
] [ ]
. The
[ ]
light up:
[ ]
Charging level
Maximum
Medium
Low
is warm:
[ ]
NOTE
The battery pack
u
charged at any time without
[ ]
reducing the life.
Interrupting the charging process
u
does not damage the battery
]
pack .
[ ]
Charge the battery pack
u
operation when it is at medium or
low charging level.
1. The charging control LEDs (green
and red
[
charger
[
LED
Red LED lights up
Green LED lights up Battery pack fully
Green and red LED
ashing
Red LED ashing
Green LED lights
up (without battery
pack)
2. Insert the battery pack
charger
[
3. Connect the mains cord with mains
plug of the charger
[ ]
mains socket.
4. When the battery pack
charged: Remove the battery
pack from the charger
disconnect the mains plug
charger from the mains socket.
may be
[ ]
before
[ ]
) indicate the status of the
]
and the battery pack
]
Status
Battery pack
charges
charged
Battery pack
defective
Battery pack too
cold or too warm
Charger ready
into the
[ ]
.
]
to the
[ ]
is fully
[ ]
. Then
[ ]
[
GB/IE/NI/CY/MT
[ ]
:
[ ]
of the
]
47