Parkside PDSA D3 Bedienungs- Und Sicherheitshinweise Seite 50

˜ 12 V
information
(Fig. J)
˜ C
WARNING!
m
Charge the battery pack
u
dry room only. Prior to inserting the
battery into the battery charger
check that the outer surface of
the battery pack is clean and dry.
There is a risk of injury due to
electric shock.
CAUTION!
m
Do not expose the battery pack
u
to extreme conditions such as
heat or impact. Risk of injury from
escaping electrolytic solution! After
eye/skin contact, rinse the affected
areas with water or a neutraliser
and consult a doctor.
NOTE
The battery pack
u
its full capacity once it has been
charged several times.
Charge the battery pack
u
using it for the first time.
Only use chargers from the
u
12 V TEAM series to recharge
the battery pack
If a fully recharged battery pack
u
lasts for considerably shorter
operating times, the battery
pack is used up and needs to be
replaced. Only use an original
replacement battery pack from the
12 V TEAM series.
Let the battery pack
u
before charging.
48 GB/IE/NI/CY/MT
in a
[ ]
,
[ ]
[ ]
only reaches
[ ]
before
[ ]
.
[ ]
[ ]
cool down
[ ]
NOTE
The battery pack
u
charged at any time without
reducing the lifetime of the battery
pack.
Interrupting the charging process
u
does not damage the battery
pack .
[ ]
Charge the battery pack
o
use when it is at medium or low
charging level.
The charging control LEDs (green
and red ) indicate the status of the
[ ]
battery charger
pack :
[ ]
LED
Green LED lights
up without battery
inserted
Green LED lights up
Red LED lights up
1. Remove the battery pack
product.
2. Insert the battery pack
battery charger
3. Connect the mains plug
socket-outlet.
4. When the battery pack
charged: Remove the battery
pack from the battery charger
Disconnect the mains plug
the socket-outlet.
may be
[ ]
before
[ ]
[
and the battery
[ ]
Status
Charger ready
for use
Battery fully
charged
Battery
charging
from the
[ ]
into the
[ ]
.
[ ]
to a
[ ]
is fully
[ ]
.
[ ]
from
[ ]
]