Troubleshooting; Disposal/Environmental Protection - Parkside Pags 20-Li A1 Originalbetriebsanleitung

GB MT IE

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Device works with interrup-
tions
Grass and shrub shears blade
(14)/(10) is getting hot
Bad cutting results
Disposal/environmental
protection
Remove the battery from the device and re-
cycle the device, battery, accessories and
packaging in an environmentally-friendly
manner.
Feed clipped branches and grass to com-
posting and do not throw them into the re-
fuse bin.
Waste electrical and electronic
equipment (WEEE) must not be dis-
posed of with domestic waste.
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at the
end of its useful life.
32
NI
Possible cause
Rechargeable battery (5) not
inserted
Rechargeable battery (5) dis-
charged
Switch lock (1) or On/Off
switch (2) defective
Defective motor
Internal loose contact
Grass and shrub shears blade
(14)/(10) is blunt or has nicks
Too much friction due to lack
of lubrication
Too much friction due to lack
of lubrication
Grass and shrub shears blade
(14)/(10) is blunt or has nicks
Grass and shrub shears blade
(14)/(10) dirty
Error correction
Inserting the battery, p. 29
Charge the battery (see the
separate operating instructions
for the rechargeable battery
and charger)
Contact the service centre.
Contact the service centre.
Grass and shrub shears blade
(14)/(10) grind (Maintenance,
p. 30) or replace (Spare
parts and accessories,
p. 35)
Oil the grass and shrub shears
blade (14)/(10)
Oil the grass and shrub shears
blade (14)/(10)
Grass and shrub shears blade
(14)/(10) grind (Maintenance,
p. 30) or replace (Spare
parts and accessories,
p. 35)
Clean the grass and shrub
shears blade (14)/(10)
Directive 2012/19/EU on waste electrical
and electronic equipment:
Consumers are legally obliged to recycle
electrical and electronic equipment in an en-
vironmentally sound manner at the end of its
life. In this way, environmentally friendly and
resource-saving recycling is ensured.
Depending on the implementation in national
law, you may have the following options:
• Return to a shop,
• Hand over to an official collection point,
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.