Tire Clearance; Remote Lock Lever Installation - SR Suntour nrx Benutzerhandbuch

SR SUNTOUR - OWNERS MANUAL

TIRE CLEARANCE !

Your SR SUNTOUR suspension fork is designed to be used with 26" tires. Each tire has a different
outer diameter (tire width and height).Therefore the clearance between your tire and fork needs
to be checked, to make sure your tire does not get in contact with any part of your fork. Keep in
mind that the narrowest part of your fork is located at the brake bosses. If you want to remove
your wheel, you might have to deflate your tire, in order to be able to pass it through your brake
bosses.
Tire Clearance Test:
Note! Using a tire which exceeds the maximum tire size suitable to your fork is very
dangerous and could cause an accident, fatal injuries or even death to the rider
1. Release all air of your fork
2. Compress your fork completely
3. Measure the distance between the top of your tire and the bottom of the crown.
Make sure the gap is not less than 10mm! Exceeding maximum tires size will cause
the tire to jam against the bottom of the crown when the fork is fully compressed.
4. Inflate the fork again
Keep in mind that if you are using a mudguard the clearance is limited! Repeat the "Tire
Clearance Test" again to make sure the gap is big enough. Every time you are going to
change your tires you have to repeat the test again!

REMOTE LOCK LEVER INSTALLATION

Mount the „Remote-Lock-Lever" on your
handlebar using a 3mm Allen key. After-
wards you can mount your brake and shif-
ting lever back on again.
Take off the plastic cover cap using a
2.5mm Allen key.
Unscrew the cable fixing bolt using a 2mm
Allen key.
NRX / NCX LITE/ NCX / CR9
3mm
1.5 Nm
2.5mm
2.0mm
NRX SERIES
7
English