Tire Clearance - SR Suntour NRX S ELD 700C LTD Bedienungsanleitung

SR SUNTOUR - OWNERS MANUAL
5. Install the brakes according to the manufacturer's instructions. Make sure to adjust the
brake pads properly. If you use a disc brake, only mount your brake to the original disc
brake mounting holes. Only use cantilever brakes which are intended to be used with
a hangerless brace. Check the installation instructions of your brake manufacturer and
follow them. Make sure you choose the correct length of the brake cable in order to not
interfere the performance of the fork.
Reinstall the wheel back on to your bike. If you are using a quick release system to fasten
6.
your wheel set, make sure that all fasteners and nuts are adjusted properly (four or more
threads have to be engaged in the nut when it is closed) In case your fork comes with a
through axle system, make sure that all fixing bolts are tightened with the appropriate
torque values. Please also refer to the Qloc section of this manual.

TIRE CLEARANCE !

Your SR SUNTOUR suspension fork is designed to be used with 26" tires. Each tire has a
different outer diameter (tire width and height).Therefore the clearance between your tire
and fork needs to be checked, to make sure your tire does not get in contact with any
part of your fork. Keep in mind that the narrowest part of your fork is located at the brake
bosses. If you want to remove your wheel, you might have to deflate your tire, in order to
be able to pass it through your brake bosses.
Tire Clearance Test:
Note! Using a tire which exceeds the maximum tire size suitable to your fork is very
dangerous and could cause an accident, fatal injuries or even death to the rider
1.
2.
3.
4.
Keep in mind that if you are using a mudguard the clearance is limited! Repeat the "Tire
Clearance Test" again to make sure the gap is big enough. Every time you are going to
change your tires you have to repeat the test again!
8
English
Release all air of your fork
Compress your fork completely
Measure the distance between the top of your tire and the bottom of the crown.
Make sure the gap is not less than 10mm! Exceeding maximum tires size will cause
the tire to jam against the bottom of the crown when the fork is fully compressed.
Inflate the fork again
NRX S ELD 700C LTD