Special Note On Model: Sf10-Ncx Ii S Rl / S Lo; Before Each Ride - SR Suntour nrx Benutzerhandbuch

SR SUNTOUR - OWNERS MANUAL

SPECIAL NOTE ON MODEL: SF10-NCX II S RL / S LO

If your bike is equiped with an NCX II S RL fork please note that there are some special
requirements for this type of fork.
The NXC II S RL was desgined to be used only with Shimano 8mm „E-thru" axles. This
system was developed by Shimano and is registered under the name of Shimano. If
you have any further questions regarding this system, please contact Shimano Inc.
directly.
Shimano compatible hubs are: HBT708 / DHT708 / SMAX60
The system is based on an quick release through axle system. Please note that the
quick release lever has be tighten with 3-4Nm.

BEFORE EACH RIDE!

Do not ride your bike, if one of the following test criteria can't be passed!
Riding your bike without eliminating any defect or carrying out the neces-
sary adjustments can result into an accident, fatal injury or even death.
►Do you notice any cracks, dents, bent or tar-
nished parts at your suspension fork or any
other part of your bicycle? If so, please con-
sult a trained and qualified bicycle mechanic
to check your fork or bike.
►Can you notice any oil leaking out your fork?
Also check out hidden areas like the bottom
side of your fork crown. If so, please consult
a trained and qualified bicycle mechanic to
check your fork or bike.
►Compress your fork with your body weight. If
it feels too soft, relating to the proper pressu-
re to achieve an accurate SAG, inflate it until
you have reached the required value. Please
also refer to chapter " SETTING SAG"
►Make sure your brakes are properly installed/
adjusted and work appropriate. This also
applies to every other part of your bike like
handlebars, pedals, crank arms, seat post,
saddle etc. Also refer to the owner's manuals
provided by all other component manufac-
turers.
►Make sure your wheels are centered perfect-
ly in order to avoid any contact with your
suspension fork or brake system.
NRX / NCX LITE/ NCX / CR9
►If you are using a quick release system to fas-
ten your wheel set, make sure that all levers
and nuts are adjusted properly. In case you
are using a through axle system, make sure
that all fixing bolts are tightened with the
appropriate torque values.
►Check the cable length and routing of your
components. Make sure they do not interfe-
re your steering actions.
►If you are using reflectors for on-road cyc-
ling, make sure they are clean and properly
installed.
►Bounce your bike slightly on the ground
while looking and listening for anything
which might be loose.
►In case you are going to mount a low-rider
on your fork, your bikes performance may
handle differently according to the additio-
nal weight. Follow the instructions given by
the manufacturers of your low-rider. Make
sure not to overstrain your low-rider. This
could also result into a failure of your SR
SUNTOUR suspension fork.
5
English