Main Menu - Carl Valentin DUOPRINT Kurzanleitung

DuoPrint
Key:
Heater resistance
Key:
Printhead temperature
Key:
Printhead 2 Offset
Key:
Motor Ramp
Key:
Input
Key:
Output
Key:
Online/Offline
Key:
Zero point adjustment
Key:
Print length +/−

Main Menu

Switch on the label printer and the display shows the main menu. The main menu shows information such as printer type,
current date and time, version number of firmware and the used FPGA.
The selected display is shown for a short time, then the indication returns to the first information.
Press key to arrive the next information display.
94
To achieve a high print quality, the indicated Ohm value must be set after an exchange of
printhead.
The heater resistance value can be set for both printheads.
Indication of printhead temperature. The printhead temperature corresponds normally to the
room temperature. In case the maximum printhead temperature is exceeded, the current print
order is interrupted and an error message appears at the printer display.
The printhead temperature is displayed for both printheads.
For setting the automatic offset for the rear printhead in order to optimise the print image..
X-adjustment: Adjusting the position of the print image of the rear printhead (colour
component) transversely to the direction of paper movement..
Y-adjustment: Adjusting the position of the print image of the rear printhead in the direction of
paper movement.
Any changes to these parameters alter the relative orientation of the print contents of the front
and rear printheads.
This function is often used for high printing speed as the tearing of transfer ribbon can be
prevented.
The higher the '++' value is set, the slower the feeding motor is accelerated.
The smaller the '− −' value is set, the faster the feeding motor is decelerated.
Indication of input signal level.
0 = Low; 1 = High
Indication of input output level
0 = Low; 1 = High
This function is activated e.g. if the transfer ribbon is to be changed. It is avoided that a print
order is processed although the module is not ready. If the function is activated then press the
key to change between Online and Offline mode. The respective state is indicated in the
display (Standard: Off).
Online: Data can be received by interface. The keys of the foil keyboard are only active, if you
changed in the Offline mode with key
Offline: The keys of the foil keyboard are still active but received data are not processed. If the
module is again in Online mode then new print orders can be again received.
Indication of value in 1/100 mm.
After replacing the printhead - the print cannot be continued at the same position on the label,
the difference can be corrected.
NOTICE!
The value for zero point adjustmentt is set ex works. After replacing the printhead,
only service personnel are allowed to set this value anew.
Indication of print layout correction in percent.
By mechanical influences (e.g. label roll size) the print layout can be printed increased and
reduced to its original size.
Value range: +10.0% to −10.0%
English
.