Service Functions - Carl Valentin DUOPRINT Kurzanleitung

Service Functions

NOTICE!
So that the distributor res. the printer manufacturer at the case of service can offer fast support, the printer is
equipped with the Service functions menu.
Necessary information such as set parameter can read directly at the printer (see chapter 6.10 on page 53).
Keys: , , ,
Label parameters
Key:
Photocell configuration -
front printhead
Key:
Photocell configuration -
back printhead
Key:
Photocell parameters
Key:
Setting mode
Key:
Paper counter:
, , , ,
Indication of label parameters in Volt.
A: Indication of minimum value.
B: Indication of difference between minimum and maximum value.
C: Indication of trigger level. The value is ascertained while measuring and can be changed.
Indication of photocell level of the front printhead.
In case of problems while positioning or measuring of label, levels for label photocell can be
set manually. Make sure that a large hub as possible (label >3 V, gap <1 V) is set.
Indication of photocell level of the rear printhead.
In case of problems while positioning or measuring of label, levels for label photocell can be
set manually. Make sure that a large hub as possible (label >3 V, gap <1 V) is set.
Photocell 1 (LS1):
Photocell 2 (LS2):
Ribbon save photocell (OLS):
Ribbon photocell (TR):
Printhead (H):
On: The Printheads can be adjusted more easily.
The following parameters are set automatically: continuous labels, label size = 50 mm. These
settings can be changed manually.
The following control functions are desactivated: 'printhead open' control, transfer ribbon
control, label photocell Off (continuous labels).
CAUTION!
Switching off the control functions can lead to uncontrolled operation of the
printer.

The setting mode is only to use for adjusting the printheads.
Off: When switching Off the printer, the setting mode is automatically deactivated.
D: Indication of printhead attainment in meters.
G: Indication of printer attainment in meters.
English
, ,
Indication of label photocell level of the front
photocell in Volt.
Indication of label photocell level of the rear printhead
in Volt.
Indication of ribbon save photocell level in Volt.
Indication of transfer ribbon photocell status (either 0
or 1).
The first value stands for the front photocell and the
second value for the rear photocell.
Indication of printhead position.
0 = printhead down
1 = printhead up
The first value stands for the front photocell and the
second value for the rear photocell.
DuoPrint
93