Rotel RX-603 Bedienungsanleitung Seite 15

SPECIFICATIONS
POWER AMPLIFIER SECTION:
Continuous Power Output:
45 watts* per channel, min. RMS both channels
driven at 8 ohms from to 20 to 20,000Hz
with no more than 0.3% total harmonic
Total Harmonic Distortion. . . . .
(20 to 20,000Hz, from AUX)
Intermodulation Distortion
(50Hz: 1 ,
from AUX)
Frequency Response .
Input Sensitivity/lmpedance. .
Damping Factor. .
PREAMPLIFIER SECTION
Input Sensitivity/lmpedance:
NO
AUX
TAPE IN 1.
TAPE IN 2.
TAPE IN 1 (DIN connector).
OverloadLevel[MaximumInput Level] (T.H.D.0.1%, I kHz)
PHONO
AUX
Output Level/lmpedance (5mV PHONO input):
TAPE OUT 1
TAPE OUT 2
TAPE OUT 1,2..
PRE OUT .
Total Harmonic Distortion. .
Frequency Response:
Tone Control:
BASS
TREBLE.
High Filter .
Loundness Contour. . .
short circuited
Hum & Noise (IHF,
PHONO .
AUX, TAPE IN
distortion.
NO more than 0.3%
(continuous rated power output)
No more than 0.1%
(I watt per channel power output
8 Ohms)
No more than 0.2%
(continuous rated power output)
No more than 0.1%
(I watt per channel power output,
8 ohms)
. 5Hz to 60,OOOHz
+OdB, -dB
(I watt per channel power output,
8 ohms)
0.9V/34 Kohms (MAIN AMP IN)
35 (20 to 20,000Hz, 8 ohms)
2.4mV/50 Kohrns
150mV/50 Kohms
150mV 150 Kohms
150mV/50 Kohms
. 150mV/50 Kohms
.
130mV (2.4mV input)
. Not less than 5 V
330mV/3.2 Kohms
330mV/3.2 Kohms
100mV/80 Kohms (DIN connectors)
0.9V /2.2 Kohms
No more than 0.05%
(20Hz to 20,OOOHz, 0.9V output)
30Hz to 15,OOOHz ±O.3dB
(RIAA Equalization)
±10dB (IOOHz)
±10dB (10kHz)
.±10dB (10kHz)
+7dB (IOOHz), +3dB (10kHz)
A network, rated power):
75dB
. 90dB
FM TUNER SECTION
Usable Sensitivity .
Usable Sensitivity(lHF '58)
50dB Quieting Sensitivity .
Signal-to-Noise Ratio (at 65dBf):
Mono. . .
Stereo
Distortion (at 65dBf):
IOOHz
IkHz .
6kHz .
Frequency Response .
Capture Ratio .
Alternate Channel Selectivity
Spurious Response Ratio.
Image Response Ratio
IF Response Ratio
AM Suppression Ratio .
Stereo Separation. . . . . . . . . .
AM TUNER SECTION
Sensitivity . .
MISCELLANEOUS
Power Consumption
Dimensions (Overall)
Weight (Net) .
NOTE. Specifications and design subject to possible modification
without notice.
*Measured pursuant to the Federal Trade Commission's
Regulation Rule on Power Claims for Amplifiers.
(Applicable to the U.S.A. only)
. 10.6dBf (1.8ßV/300 ohms)
1.8gv
16.5dBf (4/1\//300 ohms)
70dB
65dB
0.1% (mono), 0.3% (stereo)
0.1% (mono), 0.3% (stereo)
0.3% (mono), 0.5% (stereo)
30Hz to 15,000Hz +0.3dB, - ldB
2.0 dB
. 75dB
70dB
55dB
80dB
. 54dB
40dB (1kHz),
30dB (30Hz to 15kHz)
250ßV/rn (IHF, ferrite antenna),
12.5gV (IHF, ext. antenna)
350 watts (Max.)
490
1Okg
Trade
Printed in Japan 0 61-01-03